Details, datasheet, quote on part number: M27C160
PartM27C160
CategoryMemory => ROM => OTP ROM
Description16 Mbit (2MB X8 or 1MB X16) uv EPROM And OTP EPROM
CompanyST Microelectronics, Inc.
DatasheetDownload M27C160 datasheet
Quote
Find where to buy
 
  

 

Features, Applications

10% SUPPLY VOLTAGE in READ OPERATION ACCESS TIME: 50ns BYTE-WIDE or WORD-WIDE CONFIGURABLE 16 Mbit MASK ROM REPLACEMENT LOW POWER CONSUMPTION Active Current 8MHz Standby Current 100A

PROGRAMMING VOLTAGE: 0.25V PROGRAMMING TIME: 50s/word ELECTRONIC SIGNATURE Manufacturer Code: 20h Device Code: B1h

DESCRIPTION The a 16 Mbit EPROM offered in the two ranges UV (ultra violet erase) and OTP (one time programmable). It is ideally suited for microprocessor systems requiring large data or program storage and is organised as either 2 Mbit words of 8 bit or 1 Mbit words of 16 bit. The pin-out is compatible with a 16 Mbit Mask ROM. The FDIP42W (window ceramic frit-seal package) has a transparent lid which allows the user to expose the chip to ultraviolet light to erase the bit pattern. A new pattern can then be written rapidly to the device by following the programming procedure. For applications where the content is programmed only one time and erasure is not required, the M27C160 is offered SDIP42, PLCC44 and SO44 packages.

E G BYTEVPP VCC VSS NC Address Inputs Data Outputs Data Outputs Data Output / Address Input Chip Enable Output Enable Byte Mode / Program Supply Voltage Ground Not Connected Internally

Symbol TA TBIAS TSTG VIO (2) VCC VA9 (2) VPP Parameter Ambient Operating Temperature (3) Temperature Under Bias Storage Temperature Input or Output Voltage (except A9) Supply Voltage A9 Voltage Program Supply Voltage Value to 14 Unit C

Note: 1. Except for the rating "Operating Temperature Range", stresses above those listed in the Table "Absolute Maximum Ratings" may cause permanent damage to the device. These are stress ratings only and operation of the device at these or any other conditions above those indicated in the Operating sections of this specification is not implied. Exposure to Absolute Maximum Rating conditions for extended periods may affect device reliability. Refer also to the STMicroelectronics SURE Program and other relevant quality documents. 2. Minimum DC voltage on Input or Output is 0.5V with possible undershoot to 2.0V for a period less than 20ns. Maximum DC voltage on Output is VCC +0.5V with possible overshoot to VCC +2V for a period less than 20ns. 3. Depends on range.

Mode Read Word-wide Read Byte-wide Upper Read Byte-wide Lower Output Disable Program Verify Program Inhibit Standby Electronic Signature

Q15A1 Data Out VIH VIL Hi-Z Data In Data Out Hi-Z Code
Q8-Q14 Data Out Hi-Z Data In Data Out Hi-Z Codes
Q7-Q0 Data Out Data Out Data Out Hi-Z Data In Data Out Hi-Z Codes
Identifier Manufacturer's Code Device Code A0 VIL VIH 0 1 Hex Data 20h B1h

 

Related products with the same datasheet
M27C160-100-1
M27C160-150-1
M27C160-200-1
Some Part number from the same manufacture ST Microelectronics, Inc.
M27C160-100-1 16 Mbit (2MB X8 or 1MB X16) uv EPROM And OTP EPROM
M27C160-100B1TR 16 Mbit 2mb x8 or 1mb X16 uv EPROM And OTP EPROM
M27C160-10F1 16 Mbit (2mb X 8 or 1mb X 16) uv EPROM And OTP EPROM
M27C160-120B1TR 16 Mbit 2mb x8 or 1mb X16 uv EPROM And OTP EPROM
M27C160-150-1 16 Mbit (2MB X8 or 1MB X16) uv EPROM And OTP EPROM
M27C160-150B1TR 16 Mbit 2mb x8 or 1mb X16 uv EPROM And OTP EPROM
M27C160-200-1 16 Mbit (2MB X8 or 1MB X16) uv EPROM And OTP EPROM
M27C160-70B1TR 16 Mbit 2mb x8 or 1mb X16 uv EPROM And OTP EPROM
M27C160-90B1 16 Mbit (2MB X8 or 1MB X16) uv EPROM And OTP EPROM
M27C160-90B1TR 16 Mbit 2mb x8 or 1mb X16 uv EPROM And OTP EPROM
M27C2001 2 Mbit (256KB X8) uv EPROM And OTP ROM
M27C2001-10B1
M27C2001-10B1TR 2 Mbit 256kb X 8 uv EPROM And OTP EPROM
M27C2001-10C1 2 Mbit (256KB X8) uv EPROM And OTP ROM
M27C2001-10C1TR 2 Mbit 256kb X 8 uv EPROM And OTP EPROM
M27C2001-10F1 2 Megabit -256k X 8- uv EPROM And OTP ROM
M27C2001-10F1TR 2 Mbit 256kb X 8 uv EPROM And OTP EPROM
Same catergory

Am29DL640H : 64 Megabit (8M X 8-Bit/4M X 16-Bit) CMOS 3.0 Volt-only, Simultaneous R/w Flash Memory.

EBD11UD8ABDA : . The is 128M words 64 bits, 2 ranks Double Data Rate (DDR) SDRAM Small Outline Dual In-line Memory Module, mounting 16 pieces of 512M bits DDR SDRAM sealed in TCP package. Read and write operations are performed at the cross points of the CK and the /CK. This high-speed data transfer is realized by the 2 bits prefetch-pipelined architecture. Data strobe.

HYS72D32300GU-5-B : 128MB - 2GB, 184pin. 2.5V 184Pin Unbuffered DDR-I SDRAM Modules & 512MByte Modules PC2700, PC3200 Data Sheet Revision 1.01 (Feb. 2003) 184Pin Unbuffered 8-Byte Dual-In-Line DDR-I SDRAM non-parity and ECC-Modules for PC and Server main memory applications One bank 64, 32Mx72 and two bank 72 organization JEDEC standard Double Data Rate Synchronous DRAMs (DDR-I SDRAM) Single.

IDT70V658S : High-speed 3.3v 64k X 36 Asynchronous Dual-port Static RAM. True Dual-Port memory cells which allow simultaneous access of the same memory location High-speed access Commercial: 10/12/15ns (max.) Industrial: 12/15ns (max.) Dual chip enables allow for depth expansion without external logic IDT70V659 easily expands data bus width to 72 bits or more using the Master/Slave select when cascading more than one device.

K3N4C1000D : 8M bit. = K3N4C1000D 8M-Bit (1M X 8 / 512K X 16) CMOS Mask ROM ;; Organization = 1Mx8,512Kx16 ;; Voltage(V) = 5.0 ;; Speed(ns) = 100 ;; Package = 42DIP,44SOP,44TSOP2 ;; Current (mA/uA) = 50/50 ;; Production Status = Mass Production ;; Comments = Eol BY Dec. '03.

KMM5328004CSW : SIMM. = KMM5328004CSW 8MB X 32 DRAM Simm Using 4MB X 16, 4KB Refresh, 5V ;; Density(MB) = 32 ;; Organization = 8Mx32 ;; Mode = Edo ;; Refresh = 4K/64ms ;; Speed(ns) = 50,60 ;; #of Pin = 72 ;; Component Composition = (4Mx16)x4 ;; Production Status = Eol ;; Comments = -.

M27C400 : 4 Mbit (512KB X8 or 256KB X16) uv EPROM And OTP EPROM. 10% SUPPLY VOLTAGE in READ OPERATION ACCESS TIME: 55ns BYTE-WIDE or WORD-WIDE CONFIGURABLE 4 Mbit MASK ROM REPLACEMENT LOW POWER CONSUMPTION Active Current 8MHz Stand-by Current 100A PROGRAMMING VOLTAGE: 0.25V PROGRAMMING TIME: 50s/word ELECTRONIC SIGNATURE Manufacturer Code: 20h Device Code: B8h Figure 1. Logic Diagram The an 4 Mbit EPROM.

M470L2923BN0 : = M470L2923BN0 200Pin Non Ecc / Ecc Sodimm Based on 512Mb B-die ;; Density(MB) = 1024 ;; Organization = 128Mx64 ;; Bank/ Interface = 4B/SSTL2 ;; Refresh = 8K/64ms ;; Speed = CC,B3,A2,B0 ;; #of Pin = 200 ;; Power = C,l ;; Component Composition = (64Mx8)x16 ;; Production Status = Customer Sample ;; Comments = Stsop.

MSM518222A : DRAMs and ASMs->Field DRAM. 262,214-Word X 8-Bit Field Memory. The OKI is a high performance 8-bit, Field Memory. It is designed for high-speed serial access applications such as HDTVs, conventional NTSC TVs, VTRs, digital movies and Multi-media systems. is a FRAM for wide or low end use as general commodity TVs and VTRs, exclusively. The MSM518222A is not designed for the other use or high end use in medical.

MSM51V17805A : DRAMs and ASMs. 2M X 8 DRAM Edo, 3V.

THMD51E01B70 : Form = DIMM-184pin ;; Type = Unbuffered ;; Density (MB) = 512MB ;; Config. = 64Mx72 ;; Comp. = 32Mx8 ;; = PC1600, PC2100 ;; Date = 2001-08-18.

WED3DG6435V-D1 : Density = 256MB ;; Organization = 32Mx64 ;; Components = 32Mx8 (8) ;; Speed MHZ = 100-133 ;; Volt = 3.3 ;;.

HYB25DC512800CE-5 : Consumer DRAM DDR Infineon is now offering a dedicated portfolio of DRAM components for consumer applications. Profiting from its long-term leadership in high quality, high-density DRAM Infineon now introduces a broad range of consumer oriented memories..

IS41C85125A : 512K x 8 (4-MBIT) DYNAMIC RAM WITH FAST PAGE MODE The ISSI IS41C85125A and IS41LV85125A are 512,288 x 8- bit high-performance CMOS Dynamic Random Access Memories. Fast Page Mode allows 1024 random accesses within a single row with access cycle time as short as 12 ns per 8-bit word..

25AA1024 : The Microchip Technology Inc. 25AA1024/25LC1024 * ? Byte and Page-level Write Operations: (25XX1024 ) is a 1024 Kbit serial EEPROM memory - 256 byte page with byte-level and page-level serial EEPROM func- - 6 ms max. write cycle time tions. It also Page, Sector and Chip erase - No page or sector erase required functions typically associated with Flash-based.

CY7C1270V18 : 36-Mbit DDR-II+ SRAM 2-Word Burst Architecture (2.5 Cycle Read Latency) The CY7C1266V18, CY7C1277V18, CY7C1268V18, and CY7C1270V18 are 1.8V Synchronous Pipelined SRAMs equipped with DDR-II+ architecture. The DDR-II+ consists of an SRAM core with advanced synchronous peripheral circuitry.

AT45DB081D : 8M Bit, 2.5 Or 2.7-Volt Only Serial-Interface Flash 8M bit, 2.5 or 2.7-Volt Only Serial-Interface Flash.

IDT71V546S100PF9 : 128K X 36 ZBT SRAM, 5 ns, PQFP100. s: Memory Category: SRAM Chip ; Density: 4719 kbits ; Number of Words: 128 k ; Bits per Word: 36 bits ; Package Type: TQFP, 14 X 20 MM, ROHS COMPLIANT, PLASTIC, TQFP-100 ; Pins: 100 ; Logic Family: CMOS ; Supply Voltage: 3.3V ; Access Time: 5 ns ; Operating Temperature: 0 to 70 C (32 to 158 F).

PDM31548SA15SOI : 128K X 16 STANDARD SRAM, 15 ns, PDSO44. s: Memory Category: SRAM Chip ; Density: 2097 kbits ; Number of Words: 128 k ; Bits per Word: 16 bits ; Package Type: SOJ, 0.400 INCH, PLASTIC, SOJ-44 ; Pins: 44 ; Logic Family: CMOS ; Supply Voltage: 3.3V ; Access Time: 15 ns ; Operating Temperature: -40 to 85 C (-40 to 185 F).

W981616AH-6 : 1M X 16 SYNCHRONOUS DRAM, 5.5 ns, PDSO50. s: Memory Category: DRAM Chip ; Density: 16777 kbits ; Number of Words: 1000 k ; Bits per Word: 16 bits ; Package Type: TSOP, 0.400 INCH, TSOP2-50 ; Pins: 50 ; Supply Voltage: 3.3V ; Access Time: 5.5 ns ; Operating Temperature: 0 to 70 C (32 to 158 F).

 
0-C     D-L     M-R     S-Z