Details, datasheet, quote on part number: M27C202-100B1TR
PartM27C202-100B1TR
CategoryMemory => EPROM => 8 Mb
Description2 Mbit 128kb X16 uv EPROM And OTP EPROM
CompanyST Microelectronics, Inc.
DatasheetDownload M27C202-100B1TR datasheet
  

 

Features, Applications

10% SUPPLY VOLTAGE in READ OPERATION ACCESS TIME: 45ns LOW POWER CONSUMPTION: Active Current 5MHz Standby Current 100A

PROGRAMMING VOLTAGE: 0.25V PROGRAMMING TIME: 100s/word ELECTRONIC SIGNATURE Manufacturer Code: 20h Device Code: 1Ch

DESCRIPTION The a 2 Mbit EPROM offered in the two ranges UV (ultra violet erase) and OTP (one time programmable). It is ideally suited for microprocessor systems requiring large programs, in the application where the contents is stable and needs to be programmed only one time, and is organised by 16 bits. The FDIP40W (window ceramic frit-seal package) has a transparent lids which allow the user to expose the chip to ultraviolet light to erase the bit pattern. A new pattern can then be written to the device by following the programming procedure. For applications where the content is programmed only one time and erasure is not required, the M27C202 is offered PDIP40, PLCC44 and x 14 mm) packages.

A0-A16 Q0-Q15 Address Inputs Data Outputs Chip Enable Output Enable Program Supply Voltage Ground Not Connected Internally

Symbol TA TBIAS TSTG VIO (2) VCC VA9 (2) VPP Parameter Ambient Operating Temperature (3) Temperature Under Bias Storage Temperature Input or Output Voltage (except A9) Supply Voltage A9 Voltage Program Supply Voltage Value to 14 Unit C

Note: 1. Except for the rating "Operating Temperature Range", stresses above those listed in the Table "Absolute Maximum Ratings" may cause permanent damage to the device. These are stress ratings only and operation of the device at these or any other conditions above those indicated in the Operating sections of this specification is not implied. Exposure to Absolute Maximum Rating conditions for extended periods may affect device reliability. Refer also to the STMicroelectronics SURE Program and other relevant quality documents. 2. Minimum DC voltage on Input or Output is 0.5V with possible undershoot to 2.0V for a period less than 20ns. Maximum DC voltage on Output is VCC +0.5V with possible overshoot to VCC +2V for a period less than 20ns. 3. Depends on range.

Mode Read Output Disable Program Verify Program Inhibit Standby Electronic Signature
Q15-Q0 Data Output Hi-Z Data Input Data Output Hi-Z Codes
Identifier Manufacturer's Code Device Code A0 VIL VIH Q0 0 Hex Data 20h 1Ch

 

Related products with the same datasheet
M27C202-100B3TR
M27C202-100B6TR
M27C202-100F1TR
M27C202-100F3TR
M27C202-100F6TR
M27C202-100K1TR
M27C202-100K3TR
M27C202-100K6TR
M27C202-100N1TR
M27C202-100N3TR
M27C202-100N6TR
M27C202-120B1TR
Some Part number from the same manufacture ST Microelectronics, Inc.
M27C202-100B3TR 2 Mbit 128kb X16 uv EPROM And OTP EPROM
M27C202-45-1 2 Mbit (128KB X16) uv EPROM And OTP EPROM
M27C202-45B1TR 2 Mbit 128kb X16 uv EPROM And OTP EPROM
M27C202-70-1 2 Mbit (128KB X16) uv EPROM And OTP EPROM
M27C202-70B1TR 2 Mbit 128kb X16 uv EPROM And OTP EPROM
M27C202-70K6 2 Mbit (128KB X16) uv EPROM And OTP EPROM
M27C202-70K6TR 2 Mbit 128kb X16 uv EPROM And OTP EPROM
M27C202-80-1 2 Mbit (128KB X16) uv EPROM And OTP EPROM
M27C202-80B1TR 2 Mbit 128kb X16 uv EPROM And OTP EPROM
M27C202-80F1 2 Mbit (128KB X16) uv EPROM And OTP EPROM
M27C202-80F1TR 2 Mbit 128kb X16 uv EPROM And OTP EPROM
M27C256B 256 Kbit (32KB X8) uv EPROM And OTP EPROM
M27C256B-10B1TR 256 Kbit ( 32kb X 8 ) uv EPROM And OTP EPROM
Same catergory

ADS6616A4A : Synchronous DRAM ( 1m X 16 Bit X 4 Banks ).

ATMEGA32 : 8-bit Avr Microcontroller With 32k Bytes In-system Programmable Flash.

HY57V28820AT : 4Banks X 4M X 8bits Synchronous DRAM. Eleminated -10 Bining product. Changed DC Characteristics-ll. - tCK to 15ns from min in Test condition to 120mA from to 120mA from to 240mA from to 90mA from 100mA Added Burst-Read-Single-Write commend in Commend Truth Table 1.2 : Hynix Change 1.3 : Burst read single write mode correction The Hynix a 134,217,728bit CMOS Synchronous DRAM, ideally suited.

K7M403625A : NtRAM(FT & PP). = K7M403625A 128Kx36-Bit Flow-through NtRAM™ ;; Organization = 128Kx36 ;; Operating Mode = FT(SB) ;; VDD(V) = 3.3 ;; Access Time-tCD(ns) = 6.5,7.5,8.0,9.0 ;; Speed-tcyc (MHz) = 133,117,100,83 ;; I/o Voltage(V) = 3.3,2.5 ;; Package = 100TQFP ;; Production Status = Eol ;; Comments = -.

KMMR18R48C : Normal RIMM. = KMMR18R48C 8d RIMM(TM) Module With 72Mb Rdrams ;; Density(MB) = 64 ;; Organization = 32Mx18 ;; Component Composition = 8 ;; Voltage(V) = 2.5 ;; Refresh = 8K/32m(3.9us) ;; Speed(MHz)/ TRAC(ns) = 300/53.3,356/45,400/45 ;; #of Pin = 184 ;; Production Status = Eol ;; Comments = Ecc.

M15411EJ4V0DS00 : Flash Memory + Mobile Specified RAM. MCP (MULTI-CHIP PACKAGE) FLASH MEMORY AND MOBILE SPECIFIED RAM 32M-BIT FLASH MEMORY AND 16M-BIT CMOS MOBILE SPECIFIED RAM The is a stacked type MCP (Multi-Chip Package) of 33,554,432 bits (BYTE mode : 4,194,304 words by 8 bits, WORD mode : 2,097,152 words by 16 bits) flash memory and 16,777,216 bits (1,048,576 words by 16 bits) Mobile specified RAM.

M48T201 : 3.3v-5v Timekeeper(r) Controller. SUMMARY s CONVERTS LOW POWER SRAM INTO NVRAMs YEAR 2000 COMPLIANT BATTERY LOW FLAG INTEGRATED REAL TIME CLOCK, POWERFAIL CONTROL CIRCUIT, BATTERY and CRYSTAL WATCHDOG TIMER CHOICE OF WRITE PROTECT VOLTAGES (VPFD = Power-fail Deselect Voltage): M48T201Y: VCC 5.5V 4.1V VPFD M48T201V: VCC 3.6V 2.7V VPFD 3.0V MICROPROCESSOR POWER-ON RESET (Valid even.

MBM29LV800BE70 : Single 3V. 1M * 8, 512K * 16. The MBM29LV800TE/BE are 8 M-bit, 3.0 V-only Flash memories organized 1 M bytes of 8 bits each or 512 Kwords of 16 bits each. The MBM29LV800TE/BE are offered a 48-pin CSOP package. These devices are designed to be programmed in a system with the standard system 3.0 V VCC supply. 12.0 V VPP and 5.0 V VCC are not required for write or erase operations.

MC-458CB646 : 8m-word BY 64-bit Synchronous Dynamic RAM Module Unbuffered Type. The MC-458CB646EFB and MC-458CB646PFB are 8,388,608 words by 64 bits synchronous dynamic RAM module on which 4 pieces of 128M SDRAM: PD45128163 are assembled. This module provides high density and large quantities of memory in a small space without utilizing the surfacemounting technology on the printed circuit board. Decoupling capacitors are mounted.

MT5C4001J : . Industry standard x4 pinout, timing, functions, and packages High-performance, CMOS silicon-gate process Single +5V10% power supply Low-power, 2.5mW standby; 300mW active, typical All inputs, outputs, and clocks are fully TTL and CMOS compatible 1,024-cycle refresh distributed across 16ms Refresh modes: RAS\-ONLY, CAS\-BEFORE-RAS\ (CBR), and HIDDEN.

THMY7232G1EG-75 : Form = DIMM-168 Pin ;; Type = Unbuffered ;; Density (MB) = 256MB ;; Config. = 32Mx72 ;; Comp. = 16Mx8 ;; = PC100, PC133 ;; Date = 1998/12/04.

TM4100GAD8-60 : ti TM4100GAD8, 4 194 304 BY 8-Bit DRAM Module. Organization. Single 5-V Power Supply (10% Tolerance) 30-Pin Single In-Line Memory Module (SIMM) for Use With Sockets Utilizes Eight 4-Megabit DRAMs in Plastic Small-Outline J-Lead Packages (SOJs) Long Refresh Period ms (1024 Cycles) All Inputs, Outputs, Clocks Fully TTL Compatible 3-State Output Performance Ranges: ACCESS TIME tRAC (MAX) 80 ns ACCESS.

W27E020P : 256kx8, 2m, 5v, 100, 120, Chip Erase, :dip/ P:plcc. The is a high speed, low power Electrically Erasable and Programmable Read Only Memory organized 8 bits that operates on a single 5 volt power supply. The W27E020 provides an electrical chip erase function. High speed access time: 70/90/120 nS (max.) Read operating current: 30 mA (max.) Erase/Programming operating current: 30 mA (max.) Standby current:.

K4S563233F : 2M x 32Bit x 4 Banks Mobile SDRAM in 90FBGA The K4S563233F is 268,435,456 bits synchronous high data rate Dynamic RAM organized as 4 x 2,097,152 words by 32 bits, fabricated with SAMSUNGs high performance CMOS technology. Synchronous design allows precise cycle control with the use of system clock and I/O transactions are possible on every clock cycle.

EDI88128CS15CB : 128K X 8 STANDARD SRAM, 15 ns, CDIP32. s: Memory Category: SRAM Chip ; Density: 1049 kbits ; Number of Words: 128 k ; Bits per Word: 8 bits ; Package Type: DIP, 0.600 INCH, SIDE BRAZED, CERAMIC, DIP-32 ; Pins: 32 ; Logic Family: CMOS ; Supply Voltage: 5V ; Access Time: 15 ns ; Operating Temperature: -55 to 125 C (-67 to 257 F).

M36L0R7050L3ZAME : SPECIALTY MEMORY CIRCUIT, PBGA88. s: Density: 134218 kbits ; Number of Words: 8000 k ; Bits per Word: 16 bits ; Package Type: 8 X 10 MM, 0.80 MM PITCH, ROHS COMPLIANT, TFBGA-88 ; Pins: 88 ; Supply Voltage: 1.8V ; Operating Temperature: -25 to 85 C (-13 to 185 F).

MR37V6452B-XXXTA : MASK PROM. s: Memory Category: PROM, M_PROM. 16-bit/8,388,608-word 8-bit electrically switchable configuration Page size x 8-Bit Access time 3.6 V power supply 90ns MAX Page Access time30 ns MAX Operating mA MAX(5MHz) Standby current10 A MAX Input/Output TTL compatible Three-state output P2ROM stands for Production Programmed ROM. This exclusive LAPIS Semiconductor's technology utilizes factory.

 
0-C     D-L     M-R     S-Z