Details, datasheet, quote on part number: M28F201-120K1R
PartM28F201-120K1R
CategoryMemory => Flash
Description2 MB 256k X 8, Chip Erase Flash Memory
CompanyST Microelectronics, Inc.
DatasheetDownload M28F201-120K1R datasheet
Quote
Find where to buy
 
  

 

Features, Applications

10% SUPPLY VOLTAGE 12V PROGRAMMING VOLTAGE FAST ACCESS TIME: 70ns BYTE PROGRAMMING TIME: 10s typical ELECTRICAL CHIP ERASE in 1s RANGE LOW POWER CONSUMPTION Active Current: 15mA typical Stand-by Current: 10A typical 10,000 PROGRAM/ERASE CYCLES INTEGRATED ERASE/PROGRAM-STOP TIMER OTP COMPATIBLE PACKAGES and PINOUTS ELECTRONIC SIGNATURE Manufacturer Code: 20h Device Code: F4h DESCRIPTION The M28F201 FLASH Memory product is a nonvolatile memories which may be erased electrically at the chip level and programmed byte-by-byte. It is organised as 256K bytes. It uses a command register architecture to select the operating modes and thus provide a simple microprocessor interface. The M28F201 FLASH Memory product is suitable for applications where the memory has to be reprogrammed in the equipment. The access time of 70ns makes the device suitable for use in high speed microprocessor systems.

G W VPP VCC VSS April 1997 Address Inputs Data Inputs / Outputs Chip Enable Output Enable Write Enable Program Supply Voltage Ground

DEVICE OPERATION The M28F201 FLASH Memory product employs a technology similar a 2 Megabit EPROM but add to the device functionality by providing electrical erasure and programming. These functions are managed by a command register. The functions that are addressed via the command register depend on the voltage applied to the VPP, program voltage, input. When VPP is less than or equal to 6.5V, the command register is disabled and the M28F201 functions as a read only memory providing operating modes similar to an EPROM (Read, Output Disable, Electronic Signature Read and Standby). When VPP is raised to 12V the command register is enabled and this provides, in addition, Erase and Program operations. READ ONLY MODES, VPP 6.5V For all Read Only Modes, except Standby Mode, the Write Enable input W should be High. In the Standby Mode this input is 'don't care'. Read Mode. The M28F201 has two enable inputs, E and G, both of which must be Low in order to output data from the memory. The Chip Enable (E) is the power control and should be used for device selection. Output Enable (G) is the output control and should be used to gate data on to the output, independantof the device selection.

Symbol TA TSTG VIO VCC VA9 VPP Parameter Ambient Operating Temperature Storage Temperature Input or Output Voltages Supply Voltage A9 Voltage Program Supply Voltage, during Erase or Programming Value to 14 Unit C

Note: Except for the rating "Operating Temperature Range", stresses above those listed in the Table "Absolute Maximum Ratings" may cause permanent damage to the device. These are stress ratings only and operation of the device at these or any other conditions above those indicated in the Operating sections of this specification is not implied. Exposure to Absolute Maximum Rating conditions for extended periods may affect device reliability. Refer also to the SGS-THOMSON SURE Program and other relevant quality documents.

- DQ7 Data Output Hi-Z Codes Data Output Data Input Hi-Z
Output Disable Standby Electronic Signature Read
Notes: X = VIL or VIH. 2. Refer also to the Command table.
Identifier Manufacturer's Code Device Code A0 VIL VIH DQ0 0 Hex Data 20h F4h

 

Related products with the same datasheet
M28F201-120K1TR
M28F201-120K3R
M28F201-120K3TR
M28F201-120K6R
M28F201-120K6TR
M28F201-120N1R
M28F201-120N1TR
M28F201-120N3R
M28F201-120N3TR
M28F201-120N6R
M28F201-120N6TR
M28F201-120XK1R
Some Part number from the same manufacture ST Microelectronics, Inc.
M28F201-120K1TR 2 MB 256k X 8, Chip Erase Flash Memory
M28F201-120N1 Memory Configuration 256Kx8 Memory Type Flash Memory Size 2 M-bit 2Mb (256K8) Flash Memory - 120ns Access (TSOP)
M28F201-120N1R 2 MB 256k X 8, Chip Erase Flash Memory
M28F256 256k -32k X 8, Chip Erase- Flash Memory
M28F256-10B1TR 256k ( 32k X8, Chip Erase ) Flash Memory

2N7000 : N-channel 60V - 1.8 Ohm - 0.35A SOT23-3L - TO-92 STripFET™I MOSFET

L4931ABD52 : 1.2V, Low Drop Regulator

UPSD3214AV-40U6 : Flash Programmable System Device with 8032 Microcontroller Core

PSD834F5-20JIT : Flash In-system Programmable ISP Peripherals For 8-bit MCUs

M27512-3F6 : NMOS 512K 64K x 8 UV Eprom

ST62T30B_03 : 8-bit Otp/eprom MCUs WITH A/D Converter, 16-bit Auto-reload Timer, Eeprom, SPI AND UART

TS971_07 : Output Rail-to-rail very low Noise Operational Amplifier

STR711FR0H1 : 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PBGA64 Specifications: Life Cycle Stage: ACTIVE ; Clock Speed: 16.5 MHz ; ROM Type: Flash ; Supply Voltage: 3 to 3.6 volts ; I/O Ports: 30 ; Package Type: Other, 8 X 8 MM, 1.70 MM HEIGHT, LFBGA-64 ; Operating Range: Commercial ; Pin Count: 64 ; Operating Temperature: 0 to 70 C (32 to 158 F) ; Features: PWM

VND5E008MY-E : 76 A BUF OR INV BASED PRPHL DRVR, PDSO36 Specifications: Device Type: Line / Bus Driver ; Supply Voltage: Other, 13 ; Package Type: SSOP, ROHS COMPLIANT, SSOP-36 ; Pins: 36

Same catergory

820H32 : Burst SRAM. Synchronous Burst SRAMs, 2Meg, 64K X 32,3.3 V. GS820H32T/Q-150/138/133/117/100/66 TQFP, QFP Commercial Temp Industrial Temp FT pin for user configurable flow through or pipelined operation. Single Cycle Deselect (SCD) Operation. High Output Drive current. 3.3V +10%/-5% Core power supply or 3.3V I/O supply. LBO pin for linear or interleaved burst mode. Internal input resistors on mode pins allow.

A29DL324 : 32m-bit CMOS Low Voltage Dual Operation Flash Memory 4m-byte BY 8-bit ( Byte Mode ) / 2m-word BY 16-bit ( Word Mode ).

CXK1012P : 1024-bit ( 128word X 8 Bit ) Non-volatile Memory.

EDI7F342MC : Flash Modules. Organization = 2Mx32 ;; Speed (ns) = 90-150 ;; Volt = 5 ;; Package = SIMM-80 ;; Temp = ;;.

HYMD132645AL8 : 256 MB. 32Mx64 Bits Unbuffered DDR Sdram Dimm. Hynix HYMD132645A(L)8-K/H/L series is unbuffered 184-pin double data rate Synchronous DRAM Dual In-Line Memory Modules (DIMMs) which are organized as 32Mx64 high-speed memory arrays. Hynix HYMD132645A(L)8-K/H/L series consists of sixteen 16Mx8 DDR SDRAM in 400mil TSOP II packages a 184pin glass-epoxy substrate. Hynix HYMD132645A(L)8-K/H/L series provide.

IDT71V424 : 3.3v CMOS Static RAM: 512kx8. x 8 advanced high-speed CMOS Static RAM JEDEC Center Power / GND pinout for reduced noise Equal access and cycle times Commercial and Industrial: 10/12/15ns Single 3.3V power supply One Chip Select plus one Output Enable pin Bidirectional data inputs and outputs directly TTL-compatible Low power consumption via chip deselect Available 36-pin, 400 mil plastic.

IM29F004T-IM29F004B : 4M. 4 MB (512k X 8) 5v-only Flash Memory. Page erase < 4 msec typical Chip erase < 1 sec typical Self-timed program/erase operations with end-of-cycle detection Data# Polling and Toggle Bit Inadvertent write protection Glitch filtering for WE# and CE# Low Vcc 3.5 V) write inhibit Hardwired data protection Low Icc for power conservation Read: 20 ma typical Write: 30 ma typical Stand-by:.

K4E160412D : = K4E160412D 4M X 4Bit CMOS Dynamic RAM With Extended Data Out ;; Organization = 4Mx4 ;; Mode = Edo ;; Voltage(V) = 3.3 ;; Refresh = 2K/32ms ;; Speed(ns) = 50,60 ;; Package = 26SOJ,24SOJ,26TSOP2,24TSOP2 ;; Power = Normal,low ;; Production Status = Eol(ltb Order:Aug.'03) ;; Comments = LVTTL.

K6F2016V3M : = K6F2016V3M 128K X 16 Bit Super Low Power And Low Voltage Full CMOS Static RAM ;; Organization = 128Kx16 ;; Vcc(V) = 3.0~3.6 ;; Speed-tAA(ns) = 70, 85 ;; Operating Temperature = 0~70,-40~85 ;; Operating Current(mA) = 80 ;; Standby Current(uA) = 10 ;; Package = 44TSOP2,48uBGA ;; Production Status = Eol ;; Comments = -.

TMS427809A : ti TMS427809A, 2 097 152-WORD BY 8-BIT Extended Data Out DRAM. This data sheet is applicable to all TMS417809As and TMS427809A/Ps symbolized by Revision "E" and subsequent revisions as described in the device symbolization section. Organization. by 8 Bits Single Power Supply 3.3 V) Performance Ranges: ACCESS TIME tRAC tCAC tAA MAX 35 ns EDO CYCLE tHPC MIN 30 ns Extended-Data-Out (EDO) Operation CAS-Before-RAS ( CBR).

W9864G6DB : 4Mx16.

PD23C32343 : . The PD23C32343 and PD23C32383 are 33,554,432 bits mask-programmable ROM. The word organization is 2,097,152 words by 16 bits. The active levels of OE (Output Enable Input) can be selected with mask-option. The PD23C32343 and PD23C32383 are packed in 48-pin PLASTIC TSOP(I) and 48-pin TAPE FBGA. Pin compatible with NOR Flash Memory Word organization.

M25PE40-VMW6 : 512K X 8 FLASH 2.7V PROM, PDSO8. s: Memory Category: Flash, PROM ; Density: 4194 kbits ; Number of Words: 512 k ; Bits per Word: 8 bits ; Package Type: SOP, 0.208 INCH, ROHS COMPLIANT, PLASTIC, SOP-8 ; Pins: 8 ; Supply Voltage: 3V ; Data Rate: 33 MHz ; Operating Temperature: -40 to 85 C (-40 to 185 F).

93AA46A-I/MCGX : 128 X 8 MICROWIRE BUS SERIAL EEPROM, PDSO8. s: Density: 1 kbits ; Number of Words: 128 k ; Bits per Word: 8 bits ; Bus Type: Serial ; Production Status: Full Production ; Data Rate: 3 MHz ; Logic Family: CMOS ; Supply Voltage: 2.5V ; Package Type: 2 X 3 MM, 0.90 MM HEIGHT, LEAD FREE, PLASTIC, MO-229, DFN-8 ; Pins: 8 ; Operating Range: Industrial ; Operating.

 
0-C     D-L     M-R     S-Z