Details, datasheet, quote on part number: STLVDS31
PartSTLVDS31
CategoryAnalog & Mixed-Signal Processing => Amplifiers => Differential Amplifiers
DescriptionHigh Speed Differential Line Drivers
CompanyST Microelectronics, Inc.
DatasheetDownload STLVDS31 datasheet
  

 

Features, Applications

MEETS OR EXCEEDS THE REQUIREMENTS OF ANSI TIA/EIA-644 STANDARD LOW VOLTAGE DIFFERENTIAL SIGNALING WITH TYPICAL OUTPUT VOLTAGE OF 350mV AND A 100 LOAD TYPICAL OUTPUT VOLTAGE RISE AND FALL TIMES 750ps (400Mbps) TYPICAL PROPAGATION DELAY TIMES OF 1.7ns OPERATES FROM A SINGLE 3.3V SUPPLY POWER DISSIPATION 25mW TYPICAL PER DRIVER AT 200MHz DRIVER AT HIGH IMPEDANCE WHEN DISABLED OR WITH VCC =0V PIN COMPATIBLE WITH THE AM26LS31, SN65LVD31 LOW VOLTAGE TTL (LVTTL) LOGIC INPUT LEVELS

DESCRIPTION The is a quad differential line drivers that implements the electrical characteristics of low voltage differential signaling (LVDS). This signaling technique lowers the output voltage levels of 5V differential standard levels (such TIA/EIA-422B) to reduce the power, increase the switching speeds and allows operations with a ORDERING CODES

3.3V supply rail. Any of the four current mode drivers will deliver a minimum differential output voltage magnitude of 247mV into a 100 load when enabled. The intended application of this device and signalling technique is for point-to-point baseband data transmission over controlled impedance media approximately 100. The transmission media may be printed circuit board traces, backplanes or cables. The ultimate rate and distance of data transfer is dependent upon the attenuation characteristics of the media and noise coupling to the environment. The STLVDS31 is characterized for operation from to 85C.

Package SO-16 (Tube) SO-16 (Tape & Reel) TSSOP16 (Tape & Reel)
Comments 50parts per tube / 20tube per box 2500 parts per reel 2500 parts per reel

PlN N SYMBOL 4Z G GND VCC Driver Inputs Driver Outputs Driver Outputs Enable Ground Supply Voltage NAME AND FUNCTION

L=Low level, H=High Level, X=Don't care, Z= High Impedance

Symbol VCC VI Tstg Supply Voltage (Note 1) DC Input Voltage Storage Temperature Range Parameter Value -0.5 to (VCC to +150 Unit V C

Absolute Maximum Ratings are those values beyond which damage to the device may occur. Functional operation under these condition is not implied. Note 1: All voltages except differential I/O bus voltage, are with respect to the network ground terminal.

Symbol VCC VIH VILI TA Supply Voltage HIGH Level Input Voltage LOW Level Input Voltage Operating Temperature Range -40 Parameter Min. Typ. 3.3 Max. 3.6 Unit V C


 

Some Part number from the same manufacture ST Microelectronics, Inc.
STLVDS31AD
STLVDS31B High Speed Differential Line Drivers
STLVDS32 High Speed Differential Line Receivers
STLVDS32B
STLVDS3486B
STLVDS3487AD
STLVDS3487B High Speed Differential Line Drivers
STLVDS385 3.3V Programmable LVDS Transmitter 24-BIT Flat Panel Display (FPD) LINK-85MHZ
STLVDS385B +3.3V Programmable LVDS Transmitter 24-BIT Flat Panel Display (FPD) LINK-85MHZ
STLVDS385B High Speed Flat-panel Display Interface
STLVDS385BTR 3.3V Programmable LVDS Transmitter 24-BIT Flat Panel Display (FPD) LINK-85MHZ
STLVDS47 3v LVDS Quad CMOS Differential Line Driver
STLVDS47B 3V LVDS Quad CMOS Differential Line Driver
STLVDS9637B High Speed Differential Line Receivers
STM1001 Reset Circuit
STM1645-10 RF Power Module Satellite Communications Applications
STM1645-30
STM2DPFS30L P - Channel 30v - 0.145ohm - 2a Minis0-8 StripFET MOSFET Plus Schottky Rectifier
STM351-2 RF Power Module Wireless Local Loop Applications
STM376-2
STM6316 DVD Optical Disc - Integrated Solution For DVD Players

LK112SM41TR : 1.3V - Low Drop/ Low Quiescent Regulator With Inhibit

M27V160-100XF1TR : 16 Mbit 2mb x8 or 1mb X16 Low Voltage uv EPROM And OTP EPROM

M48Z128CS : 1 Mbit 128kb x8 Zeropower SRAM

PSD835F1V-C-90J : Configurable Memory System on a Chip For 8-bit Microcontrollers

M93C86-RMN3TP/W : 16kbit, 8kbit, 4kbit, 2kbit and 1kbit (8-bit or 16-bit Wide) Microwire Serial Access Eeprom

PSD834F5A-90J : Flash In-system Programmable ISP Peripherals For 8-bit MCUs

M30LW128D110N1T : 128 Mbit (two 64mbit, X8/x16, Uniform Block, Flash Memories) 3V Supply, Multiple Memory Product

ST2L05R2815K5 : DUAL OUTPUT, FIXED POSITIVE REGULATOR, PSSO4 Specifications: Regulator Type: Standard ; Output Polarity: Positive ; Output Voltage Type: Fixed ; Package Type: Other, PPAK-5 ; Life Cycle Stage: ACTIVE ; Output Voltage: 2.42 to 2.58 volts ; IOUT: 1 amps ; VIN: 4.5 to 7 volts

STM32F107VCH6TR : 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, PQFP64 Specifications: Life Cycle Stage: ACTIVE ; Clock Speed: 50 MHz ; ROM Type: Flash ; Supply Voltage: 2 to 3.6 volts ; I/O Ports: 51 ; Package Type: LFQP, Other, 10 X 10 MM, 0.50 MM PITCH, ROHS COMPLIANT, LQFP-64 ; Operating Range: Industrial ; Pin Count: 64 ; Operating Temperature: -40 to 105 C (-40 t

Same catergory

2SC5563 : NPN Triple Kiffused Type ( Dynamic Focus Applications ).

CGY0819 : GAAS Mmic. Tri mode power amplifier for AMPS/ CDMA /TDMA portable cellular phones Dual band operation 31.5 dBm saturated output power @ PAE=55% typ. 29 dBm linear output power@ PAE=40% typ. Two independent amplifier chains Power ramp control Input matched to 50 ohms, simple output match on PCB ESD: Electrostatic discharge sensitive device, observe handling precautions!.

CWB4500CP : CMOS/dmos Wideband High-frequency Multiplexer. The is a very high performance Monolithic 4 Channel Wideband/Video Multiplexer designed for switching wide bandwidth analog and digital signals. The high speed, low ON resistance and low capacitance is achieved through Calogic's proprietary CMOS/DMOS process that combines low-power CMOS control logic with very fast DMOS switching FETs. ORDERING INFORMATION.

DG442/883 : Monolithic Quad SPST CMOS Analog Switches. Monolithic Quad SPST CMOS Analog Switches The DG441/883 and DG442/883 monolithic CMOS analog switches are drop-in replacements for the popular DG201A/ 883 and DG202/883 series devices. They include four independent single pole single throw (SPST) analog switches, TTL and CMOS compatible digital inputs, and a voltage reference for logic thresholds. These.

HA12192F : Audio Signal Processor For Car Deck ( Decode Only Dolby B-type NR With PB Amp. ).

OPA4243EA : Quad Operational Amplifier Micropower, Single-supply. For most current data sheet and other product information, visit www.burr-brown.com q MICRO-SIZE, TSSOP PACKAGE q SINGLE-SUPPLY OPERATION q WIDE SUPPLY RANGE: 36V q LOW QUIESCENT CURRENT: 45A/chan q WIDE BANDWIDTH: 430kHz q WIDE INPUT/OUTPUT SWING The is a four-channel op amp specifically designed for high density, space-limited applications, such.

TLC1078 : . Power Dissipation as Low 10 W Typ Per Amplifier Operates on a Single Silver-Oxide Watch Battery, VDD 1.4 V Min VIO. V/850 V Max in DIP and Small-Outline Package (TLC1078/79) Input Offset Voltage Drift. 0.1 V/Month Typ, Including the First 30 Days High-impedance LinCMOS Inputs IIB 0.6 pA Typ High Open-Loop Gain. 800 000 Typ Output Drive Capability.

TPA0222PWP : ti TPA0222, Stereo 2-W Audio Power Amp With 4 Selectable Gain Settings And Mux Control.

UC2854B : Power. Enhanced High Power Factor Preregulator. Controls Boost PWM to Near Unity Power Factor Limits Line Current Distortion To <3% World-Wide Operation Without Switches Accurate Power Limiting Fixed Frequency Average Current Mode Control High Bandwidth (5MHz), Low Offset Current Amplifier Integrated Current and Voltage Amp Output Clamps Multiplier Improvements: Linearity, 500mV VAC Offset (eliminates.

XNE5230CU : NE5230; SA5230; Low-voltage Operational Amplifier. Product data Supersedes data of 1994 Aug 31 File under Integrated Circuits, IC11 Handbook 2001 Aug 03 The is a very low voltage operational amplifier that can perform with a voltage supply as low or as high V. In addition, split or single supplies can be used, and the output will swing to ground when applying the latter. There is a bias adjusting pin which.

LMH6704 : High-speed buffer (650 MHz Progammable Gain Buffer with Disable) The LMH6704 is a very wideband, DC coupled programmable gain buffer designed specifically for wide dynamic range systems requiring exceptional signal fidelity. The LMH6704 includes on chip feedback and gain set resistors, simplifying PCB layout while providing user programmable gains.

DS1841 : Temperature-Controlled, NV, IC, Logarithmic Resistor The DS1841 is a 7-bit, logarithmic, nonvolatile (NV) digital resistor that an on-chip temperature sensor and associated analog-to-digital converter (ADC). The integrated temperature sensor indexes a 72-byte NV lookup table (LUT) encompassing a temperature range from -40C to +100C. The LUT output.

PI3A114-A : 1:4 Mux/Demux With Low Threshold Control Inputs 1:4 Mux/Demux with Low Threshold Control Inputs.

MAX9691 : Single/Dual, Ultra-Fast, ECL-Output Comparators With Latch Enable The MAX9691/MAX9692/MAX9693 are ultra-fast ECL comparators capable of very short propagation delays. Their design maintains the excellent DC matching characteristics normally found only in slower comparators. The MAX9691/MAX9692/MAX9693 have differential inputs and complementary outputs.

 
0-C     D-L     M-R     S-Z