Details, datasheet, quote on part number: TC626040VAB
PartTC626040VAB
CategoryPower Management
DescriptionTemperature Limit Switch
CompanyTelCom Semiconductor
DatasheetDownload TC626040VAB datasheet
Quote
Find where to buy
 
  

 

Features, Applications

FEATURES

Requires No External Components On-Chip Temperature Sensing TO-220 package for "Hot Spot" Mounting 50mA Output Signal TO-220 Package (TC626VAB) TO-92 Package for Direct Circuit Board Mounting

The is a temperature limit detector that notifies the system when measured temperature is above the factory-programmed setting. It is designed to replace mechanical (bimetal) temperature limit switches and offers increased ruggedness, higher reliability and greater setpoint accuracy. It requires no external components. The TC626 operates over to +125C temperature range. It is available a TO-92 package, which is ideal for ambient temperature sensing applications. It is also available a TO-220-3 package for heatsink temperature measurement applications.

APPLICATIONS

Vibration-Immune Temperature Sensing Fan Speed Control Circuits System Overtemperature Shutdown Advanced Thermal Warning Consumer Products

TO 18V PIN 1 SWITCHES 'HIGH' IF TEMPERATURE GOES ABOVE THE PRESET VALUE. 1 TC626 RELAY 3 SYSTEM POWER

*Trip-point temperature is designated as follows: Part numbers are or TC626VZB, where xxx = trip-point tempeature in C. For high volume applications requiring different trip-points, contact factory.

Package Power Dissipation (TA TO-92...........................................................440mW TO-220............................................................1.6mW Supply Voltage............................................................20V Input Voltage Any Input...... (GND 0.3V) to (VDD + 0.3V) Operating Temperature......................... to +125C Maximum Junction Temperature........................... +150C Storage Temperature............................ to +150C Lead Temperature (Soldering, 10 sec)................. +300C

*Stresses above those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. These are stress ratings only and functional operation of the device at these or any other conditions above those indicated in the operation sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.

Supply Voltage Supply Current Output Resistance Output Current Absolute Accuracy Trip Point Hysteresis

Output High or Low Source/Sink, VCC = 18V Source/Sink, VCC 4.5V At trip point

TelCom Semiconductor reserves the right to make changes in the circuitry or specifications detailed in this manual at any time without notice. Minimums and maximums are guaranteed. All other specifications are intended as guidelines only. TelCom Semiconductor assumes no responsibility for the use of any circuits described herein and makes no representations that they are free from patent infringement.

The TC626 output maintains a logic low state when measured temperature is below the factory-programmed setting. As temperature rises, the output is driven active to a high level [VDD (IOUT)(ROUT)] when temperature equals the setpoint value 3C. Built-in hysteresis prevents output "chattering" when measured temperature is at (or near) the trip point (Figure 1). As temperature falls through the trip point, hysteresis maintains the output high until measured temperature is 5C lower than the trip point setting. The TC626VZB (TO-92 package) has a maximum output current of 10mA while the TC626VAB has a maximum output current of 50mA. Care must be taken to observe these output current limits as output currents in excess of those stated will cause device self-heating resulting in erroneous temperature measurements.


 

Related products with the same datasheet
TC626040VZB
TC626050VAB
TC626050VZB
TC626080VAB
TC626080VZB
TC626090VAB
TC626090VZB
TC626100VAB
TC626100VZB
Some Part number from the same manufacture TelCom Semiconductor
TC626040VZB Temperature Limit Switch
TC648
TC649
TC660 100ma Charge Pump Dc-to-dc Voltage Converter
TC660CPA 100mA Charge Pump Dc-to-dc Voltage Converter. Converts (+1.5V to 5.5V) to (-1.5V to -5.5V)
TC660EOA 100ma Charge Pump Dc-to-dc Voltage Converter
TC682 Inverting Voltage Doubler
TC682CPA
TC682EOA
TC70 Micromaster - System Supervisor With Power Supply Monitor, Watchdog And Battery Backup
TC71
TC7106
TC7106A
TC7106ACPL 3-1/2 Digit A/D Converter. Drive LCD Display Directly. Internal Reference With Low Temperature Drift 20ppm/degC,typ.
TC7106ARCKW
TC7106ARCLW
TC7106ARCPL
TC7106ARIJL
TC7106ARIPL
TC7106CPL
TC7106RCKW
 
0-C     D-L     M-R     S-Z