|Category||Logic => Schmitt Triggers => CMOS/BiCMOS->AC/ACT Family|
|Description||Hex Schmitt-trigger Inverter|
|Company||Texas Instruments, Inc.|
|Datasheet||Download 74AC11014 datasheet
Flow-Through Architecture Optimizes PCB Layout Center-Pin VCC and GND Configurations Minimize High-Speed Switching Noise EPIC TM (Enhanced-Performance Implanted CMOS) 1-µm Process 500-mA Typical Latch-Up Immunity at 125°C Package Options Include Plastic SmallOutline (DW) Packages, Ceramic Chip Carriers (FK) and Flatpacks (W), and Standard Plastic (N) and Ceramic (J) DIPsdescription
The 'AC11014 contains six independent inverters. They perform the Boolean function = A. Because of the Schmitt action, the devices have different input threshold levels for positive-going (VT+) and for negative-going (VT) signals. These circuits are temperature compensated. They can be triggered from the slowest of input ramps and still give clean, jitter-free output signals and greater noise margin than conventional inverters. The 54AC11014 is characterized for operation over the full military temperature range to 125°C. The 74AC11014 is characterized for operation from to 85°C. No internal connection FUNCTION TABLE (each inverter) INPUT H L OUTPUT L H
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet. EPIC is a trademark of Texas Instruments Incorporated.
PRODUCTION DATA information is current as of publication date. Products conform to specifications per the terms of Texas Instruments standard warranty. Production processing does not necessarily include testing of all parameters.
This symbol is in accordance with ANSI/IEEE Std 91-1984 and IEC Publication 617-12. Pin numbers shown are for the DW, J, N, and W packages.absolute maximum ratings over operating free-air temperature range (unless otherwise noted)
Supply voltage range, VCC. 7 V Input voltage range, VI (see Note V to VCC 0.5 V Output voltage range, VO (see Note V to VCC 0.5 V Input clamp current, IIK (VI VI > VCC). 20 mA Output clamp current, IOK (VO VO > VCC). 50 mA Continuous output current, IO (VO 0 to VCC). 50 mA Continuous current through VCC or GND. ±150 mA Storage temperature range, Tstg. to 150°C
Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability. NOTE 1: The input and output negative-voltage ratings may be exceeded if the input and output clamp-current ratings are observed.
54AC11014 MIN VCC VIH Supply voltage High-level input voltage VCC 3 V VCC 4.5 V VCC 5.5 V VCC 3 V VIL VI VO IOH Low-level input voltage Input voltage Output voltage High-level output current VCC 3 V VCC 4.5 V VCC 5.5 V VCC 3 V IOL TA Low-level output current Operating free-air temperature VCC 3 V VCC 55 VCC 4.5 V VCC 5.5 V VCC NOM 5 MAX 5.5 74AC11014 MIN VCC °C mA NOM 5 MAX 5.5 UNIT V
electrical characteristics over recommended operating free-air temperature range (unless otherwise noted)
VI = VCC or GND 5V 3.5 Not more than one output should be tested at a time, and the duration of the test should not exceed 10 ms.
switching characteristics over recommended operating free-air temperature range, VCC 0.3 V (unless otherwise noted) (see Figure 1)
PARAMETER tPLH tPHL FROM (INPUT) A TO (OUTPUT) Y MIN = 25°C TYP MAX 54AC11014 MIN 1.2 1.7 MAX 9.9 74AC11014 MIN 1.2 1.7 MAX 9.8 9.3 UNIT ns
|Some Part number from the same manufacture Texas Instruments, Inc.|
|74AC11014DW ti 74AC11014, Hex Inverters With Schmitt-trigger|
|74AC11020D ti 74AC11020, Dual 4-Input Positive-nand Gates|
|74AC11021 Dual 4-input Positive-and Gate|
|74AC11021D ti 74AC11021, Dual 4-Input Positive-and Gates|
|74AC11027 Triple 3-input Positive-nOR GATE|
|74AC11027D ti 74AC11027, Triple 3-Input Positive-nOR GATEs|
|74AC11030 8-input Positive-nand Gate|
|74AC11030D ti 74AC11030, 8-Input Positive-nand Gates|
|74AC11032 Quadruple 2-input Positive-OR GATE|
|74AC11032D ti 74AC11032, Quadruple 2-Input Positive-OR GATEs|
|74AC11032DB Quadruple 2-input Positive-OR GATE|
|74AC11032DBLE ti 74AC11032, Quadruple 2-Input Positive-OR GATEs|
|74AC11034 Hex Noninverter|
|74AC11034DW ti 74AC11034, Hex Noninverting Drivers|
|74AC11074 Dual D-type Positive Edge Triggered Flip-flop With Clear|
|74AC11074D ti 74AC11074, Dual Positive-edge-triggered D-type Flip-flops With Clear And Preset|
|74AC11074PW Dual Positive-edge-triggered D-type Flip-flop With Clear And Preset|
|74AC11074PWLE ti 74AC11074, Dual Positive-edge-triggered D-type Flip-flops With Clear And Preset|
|74AC11086 Quad 2-input Exclusive OR GATE|
|74AC11086D ti 74AC11086, Quadruple 2-Input Exclusive-OR GATEs|
5962-8995401EA : ti CD54HC4520, High Speed CMOS Logic Dual Binary Up-counter
TIL188-1 : ti TIL188-1, A-c Input Optocoupler/optoisolator
AM26LV32E-EP : Enhanced Product Low-Voltage High-Speed Quad Differential Line Receiver, +/-15-kV IEC ESD The AM26LV32E consists of quadruple differential line receivers with 3-state outputs. These differential receivers have ±15-kV ESD (HBM and IEC61000-4-2, Air-Gap Discharge) and ±8-kV ESD (IEC61000-4-2, Contact
SN74LS368ANSRE4 : Quadruple 2-input Multiplexers WITH Storage
TL103WIDRE4 : DUAL Operational Amplifiers WITH Internal Reference
7BT2F9B-364 : HIGH Capacity Environmentally Sealed
SN74AUP1G125YFPR : Low-power DUAL 2-input Positive-and GATE
CD4007UBPWG4 : Logic - Specialty Logic Integrated Circuit (ics) Complementary Pair Plus Inverter Tube 3 V ~ 18 V; IC DUAL COMPL PAIR W/INV 14TSSOP Specifications: Logic Type: Complementary Pair Plus Inverter ; Mounting Type: Surface Mount ; Package / Case: 14-TSSOP (0.173", 4.40mm Width) ; Supply Voltage: 3 V ~ 18 V ; Packaging: Tube ; Operating Temperature: -55°C ~ 125°C ; Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant
TPS2053BEVM-294 : Eval And Demo Board And Kit Programmers, Development System; TPS2053BEVM-294 Specifications: Main Purpose: Power Management, Power Distribution Switch (Load Switch) ; Primary Attributes: 2.7 V ~ 5.5 V Input Voltage ; Secondary Attributes: Short-Circuit, Thermal & Undervoltage Protection ; Supplied Contents: Board ; Utilized IC / Part: TPS2053B ; Embedded: No ; Lead Free
74HC243 : 74HC/HCT243; Quad Bus Transceiver; 3-state;; Package: SOT108-1 (SO14), SOT27-1 (DIP14), SOT337-1 (SSOP14).
74LVQ86 : CMOS/BiCMOS->LV/LVQ/LVX Family->Low Voltage. Low Voltage Quad 2-Input Exclusive-OR GATE.
74V1T70S : Single Buffer. HIGH SPEED: tPD 5.5 ns (TYP.) at VCC = 5V LOW POWER DISSIPATION: ICC 1 µA (MAX.) 25 oC COMPATIBLE WITH TTL OUTPUTS: VIH = 2V (MIN), VIL = 0.8V (MAX) POWER DOWN PROTECTION ON INPUT SYMMETRICAL OUTPUT IMPEDANCE: |IOH| = IOL 8 mA (MIN) BALANCED PROPAGATION DELAYS: tPLH tPHL OPERATING VOLTAGE RANGE: VCC (OPR) to 5.5V IMPROVED LATCH-UP IMMUNITY ORDER CODE:.
HD74LS165A : Parallel-load 8-bit Shift Register. Regarding the change of names mentioned in the document, such as Hitachi Electric and Hitachi XX, to Renesas Technology Corp. The semiconductor operations of Mitsubishi Electric and Hitachi were transferred to Renesas Technology Corporation on April 1st 2003. These operations include microcomputer, logic, analog and discrete devices, and memory chips.
IDT74ALVC08 : CMOS/BiCMOS->LVC/ALVC/VCX Family->Low Voltage. 3.3v CMOS Quadruple 2-input Positive-and Gate.
MC68194FJ : Carrier Band Modem (CBM) , Package: N/A, Pins=52. The bipolar LSI MC68194 Carrier Band Modem (CBM) when combined with the MC68824 Token Bus Controller provides an IEEE 802.4 single channel, phasecoherent carrier band Local Area Network (LAN) connection. The CBM performs the Physical Layer function including symbol encoding/decoding, signal transmission and reception, and physical management. include:.
NC7NZ14L8X : Tinylogic Uhs Inverter With Schmitt Trigger Input. NC7NZ14 TinyLogic UHS Inverter with Schmitt Trigger Input The is a triple Inverter with Schmitt Trigger input from Fairchild's Ultra High Speed Series of TinyLogic. The device is fabricated with advanced CMOS technology to achieve ultra high speed with high output drive while maintaining low static power dissipation over a very broad VCC operating range.
PI74FCT162H827T : CMOS/BiCMOS->FCT/FCT-T Family. Fast CMOS Sb-20-bit Buffers. Common : PI74FCT16827T, PI74FCT162827T, and PI74FCT2H827T are high-speed, low power devices with high current drive VCC 5V ±10% Hysteresis on all inputs Packages available: 56-pin 240 mil wide plastic TSSOP (A) 56-pin 300 mil wide plastic SSOP (V) PI74FCT16827T : High output drive: IOH = 32 mA; IOL = 64 mA Power off disable outputs permit "live insertion".
SN54F74FK : Dual Positive-edge-triggered D-type Flip-flops With Clear And Preset. SN54F74, SN74F74 DUAL POSITIVE-EDGE-TRIGGERED D-TYPE FLIP-FLOPS WITH CLEAR AND PRESET Package Options Include Plastic Small-Outline Packages, Ceramic Chip Carriers, and Standard Plastic and Ceramic 300-mil DIPs These devices contain two independent positiveedge-triggered D-type flip-flops. A low level at the preset (PRE) or clear (CLR) inputs sets or resets.
SN54HC258 : Quad 2-line to 1-line Data Se;ectors/multiplexers With 3-state Outputs.
SN74AC241DB : Octal Buffers/drivers With 3-state Outputs. EPIC TM (Enhanced-Performance Implanted CMOS) 1-µm Process Package Options Include Plastic Small-Outline (DW), Shrink Small-Outline (DB), and Thin Shrink Small-Outline (PW) Packages, Ceramic Chip Carriers (FK), Flat (W), and DIP (J, N) Packages These octal buffers and line drivers are designed specifically to improve the performance and density of 3-state.
SN74F2373 : Bipolar->F Family. 25 Ohms Octal Tranparent D-type Latch With 3-state Outputs.
SN74LV4040A : CMOS/BiCMOS->LV/LVQ/LVX Family->Low Voltage. 12-bit Asynchronous Binary Counters.
TC74ACT32 : CMOS/BiCMOS->AC/ACT Family. Quad 2-input OR GATE.
RH1020-CQG172V : FPGA, 547 CLBS, 2000 GATES, CQFP172. s: System Gates: 2000 ; Logic Cells / Logic Blocks: 547 ; Package Type: QFP, Other, CERAMIC, MO-113, QFP-172 ; Logic Family: CMOS ; Pins: 172 ; Operating Temperature: -55 to 125 C (-67 to 257 F) ; Propagation Delay: 3.9 ns ; Supply Voltage: 5V.
74AC138SCQR : AC SERIES, OTHER DECODER/DRIVER, INVERTED OUTPUT, PDSO16. s: Function: Decoder ; Package Type: SOIC, SOIC-16 ; Logic Family: CMOS ; Number of Pins: 16 ; Propagation Delay: 14 ns ; Operating Temperature: -40 to 85 C (-40 to 185 F).