|
Details, datasheet, quote on part number:SN74ABT16825
| |
Datasheet text preview:
SN54ABT16825, SN74ABT16825 18-BIT BUFFERS/DRIVERS WITH 3-STATE OUTPUTS
SCBS218D JUNE 1992 REVISED OCTOBER 2000
D D D D D D D
Members of Texas Instruments' WidebusTM Family Latch-Up Performance Exceeds 500 mA Per JEDEC Standard JESD 17 Typical VOLP (Output Ground Bounce) <1 V at VCC = 5 V, TA = 25°C High-Impedance State During Power Up and Power Down Distributed VCC and GND Pins Minimize High-Speed Switching Noise Flow-Through Architecture Optimizes PCB Layout High-Drive Outputs (32-mA IOH, 64-mA IOL)
SN54ABT16825 . . . WD PACKAGE SN74ABT16825 . . . DL PACKAGE (TOP VIEW)
description
The 'ABT16825 devices are 18-bit buffers and line drivers designed specifically to improve both the performance and density of 3-state memory address drivers, clock drivers, and bus-oriented receivers and transmitters. These devices can be used as two 9-bit buffers or one 18-bit buffer. They provide true data. The 3-state control gate is a 2-input AND gate with active-low inputs so that, if either output-enable (OE1 or OE2) input is high, all nine affected outputs are in the high-impedance state. When VCC is between 0 and 2.1 V, the device is in the high-impedance state during power up or power down. However, to ensure the high-impedance state above 2.1 V, OE should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver. ORDERING INFORMATION
TA 40°C to 85°C to 85°C PACKAGE SSOP DL DL Tube Tape and reel
1OE1 1Y1 1Y2 GND 1Y3 1Y4 VCC 1Y5 1Y6 1Y7 GND 1Y8 1Y9 GND GND 2Y1 2Y2 GND 2Y3 2Y4 2Y5 VCC 2Y6 2Y7 GND 2Y8 2Y9 2OE1
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28
56 55 54 53 52 51 50 49 48 47 46 45 44 43 42 41 40 39 38 37 36 35 34 33 32 31 30 29
1OE2 1A1 1A2 GND 1A3 1A4 VCC 1A5 1A6 1A7 GND 1A8 1A9 GND GND 2A1 2A2 GND 2A3 2A4 2A5 VCC 2A6 2A7 GND 2A8 2A9 2OE2
ORDERABLE PART NUMBER SN74ABT16825DL SN74ABT16825DLR
TOP-SIDE MARKING ABT16825
55°C to 125°C CFPWD Tube SNJ54ABT16825WD SNJ54ABT16825WD Package drawings, standard packing quantities, thermal data, symbolization, and PCB design guidelines are available at www.ti.com/sc/package.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet. Widebus is a trademark of Texas Instruments.
UNLESS OTHERWISE NOTED this document contains PRODUCTION DATA information current as of publication date. Products conform to specifications per the terms of Texas Instruments standard warranty. Production processing does not necessarily include testing of all parameters. POST OFFICE BOX 655303
Copyright © 2000, Texas Instruments Incorporated
· DALLAS, TEXAS 75265
1
SN54ABT16825, SN74ABT16825 18-BIT BUFFERS/DRIVERS WITH 3-STATE OUTPUTS
SCBS218D JUNE 1992 REVISED OCTOBER 2000
FUNCTION TABLE (each 9-bit section) INPUTS OE1 L L H X OE2 L L X H A L H X X OUTPUT Y L H Z Z
logic symbol
1 1OE1 56 1OE2 2OE1 2OE2 1A1 1A2 1A3 1A4 1A5 1A6 1A7 1A8 1A9 2A1 2A2 2A3 2A4 2A5 2A6 2A7 2A8 2A9 28 29 55 54 52 51 49 48 47 45 44 41 40 38 37 36 34 33 31 30 2 & EN2 2 3 5 6 8 9 10 12 13 16 17 19 20 21 23 24 26 27 & EN1
1
1Y1 1Y2 1Y3 1Y4 1Y5 1Y6 1Y7 1Y8 1Y9 2Y1 2Y2 2Y3 2Y4 2Y5 2Y6 2Y7 2Y8 2Y9
This symbol is in accordance with ANSI/IEEE Std 91-1984 and IEC Publication 617-12.
logic diagram (positive logic)
1OE1 1OE2 1 56 2OE1 2OE2 2 28 29
1A1
55
1Y1
2A1
41
16
2Y1
To Eight Other Channels
To Eight Other Channels
2
POST OFFICE BOX 655303
· DALLAS, TEXAS 75265
SN54ABT16825, SN74ABT16825 18-BIT BUFFERS/DRIVERS WITH 3-STATE OUTPUTS
SCBS218D JUNE 1992 REVISED OCTOBER 2000
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)
Supply voltage range, VCC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.5 V to 7 V Input voltage range, VI (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.5 V to 7 V Voltage range applied to any output in the high or power-off state, VO . . . . . . . . . . . . . . . . . . . 0.5 V to 5.5 V Current into any output in the low state, IO: SN54ABT16825 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 96 mA SN74ABT16825 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 128 mA Input clamp current, IIK (VI < 0) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 mA Output clamp current, IOK (VO < 0) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 mA Package thermal impedance, JA (see Note 2) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 56°C/W Storage temperature range, Tstg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65°C to 150°C
Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability. NOTES: 1. The input and output negative-voltage ratings may be exceeded if the input and output clamp-current ratings are observed. 2. The package thermal impedance is calculated in accordance with JESD 51-7.
recommended operating conditions (see Note 3)
SN54ABT16825 MIN VCC VIH VIL VI IOH IOL t/v t/VCC Supply voltage High-level input voltage Low-level input voltage Input voltage High-level output current Low-level output current Input transition rise or fall rate transition rise or fall rate Power-up ramp rate Control pins Data pins 200 0 4.5 2 0.8 VCC 24 48 4 10 200 0 MAX 5.5 SN74ABT16825 MIN 4.5 2 0.8 VCC 32 64 4 10 MAX 5.5 UNIT V V V V mA mA ns/V µs/V
TA Operating free-air temperature 55 125 40 85 °C NOTE 3: All unused inputs of the device must be held at VCC or GND to ensure proper device operation. Refer to the TI application report, Implications of Slow or Floating CMOS Inputs, literature number SCBA004.
PRODUCT PREVIEW information concerns products in the formative or design phase of development. Characteristic data and other specifications are design goals. Texas Instruments reserves the right to change or discontinue these products without notice.
POST OFFICE BOX 655303
· DALLAS, TEXAS 75265
3
|
|
