Details, datasheet, quote on part number: TPS3808G12
DescriptionLow Quiescent Current, Programmable-delay Supervisory Circuit
CompanyTexas Instruments, Inc.
DatasheetDownload TPS3808G12 datasheet
Cross ref.Similar parts: NCP303
Find where to buy


Features, Applications


Power-On Reset Generator with Adjustable Delay Time: to 10s Very Low Quiescent Current: 2.4-A typ High Threshold Accuracy: 0.5% typ Fixed Threshold Voltages from 5 V and Adjustable Voltage Down 0.4 V Are Available Manual Reset (MR) Input Open-Drain RESET Output Temperature Range: to 125C Small SOT23 Package


The TPS3808xxx family of microprocessor supervisory circuits monitor system voltages from 5.0 V, asserting an open drain RESET signal when the SENSE voltage drops below a preset threshold or when the manual reset (MR) pin drops to a logic low. The RESET output remains low for the user adjustable delay time after the SENSE voltage and manual reset (MR) return above their thresholds. The TPS3808 uses a precision reference to achieve 0.5% threshold accuracy for VIT 3.3V. The reset delay time can be set 20ms by disconnecting the CT pin, 300ms by connecting the CT pin to VDD using a resistor, or can be user-adjusted between 1.25ms and 10s by connecting the CT pin to an external capacitor. The TPS3808 has a very low typical quiescent current it is well-suited to battery-powered applications. It is available in a small SOT23 package and is fully specified over a temperature range to 125C.


DSP or Microcontroller Applications Notebook/Desktop Computers PDAs/Hand-Held Products Portable/Battery-Powered Products FPGA/ASIC Applications

Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.

PRODUCTION DATA information is current as of publication date. Products conform to specifications per the terms of the Texas Instruments standard warranty. Production processing does not necessarily include testing of all parameters.

This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with appropriate precautions. Failure to observe proper handling and installation procedures can cause damage. ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be more susceptible to damage because very small parametric changes could cause the device not to meet its published specifications. ORDERING INFORMATION

PRODUCT NOMINAL SUPPLY VOLTAGE (1) Adjustable 3.3V 5.0V THRESHOLD VOLTAGE (VIT) 3.07V 4.65V SPECIFIED TEMPERATURE RANGE to +125C PACKAGE MARKING AVW AVV AVY AVS AVR AVQ AVP AVO AVN ORDERING NUMBER TPS3808G50DBVT TPS3808G50DBVR TRANSPORT MEDIA, QUANTITY Tape and Reel, 250 Tape and Reel, 3000 Tape and Reel, 250 Tape and Reel, 3000 Tape and Reel, 250 Tape and Reel, 3000 Tape and Reel, 250 Tape and Reel, 3000 Tape and Reel, 250 Tape and Reel, 3000 Tape and Reel, 250 Tape and Reel, 3000 Tape and Reel, 250 Tape and Reel, 3000 Tape and Reel, 250 Tape and Reel, 3000 Tape and Reel, 250 Tape and Reel, 3000

Custom threshold voltages from 5.0 V are available on a quick-turn basis for fast prototyping. Minimum order quantities apply. Contact factory for details and availability. Available July, 2004.

over operating junction temperature range (unless otherwise noted) (1)

TPS3808 Input voltage range, VDD CT voltage range, VCT Other voltage ranges: VRESET, VMR, VSENSE RESET pin current Operating junction temperature range, TJ (2) Storage temperature range, TSTG ESD rating, HBM ESD rating, CDM -0.3 to VDD 2 500 UNIT kV V

Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated under the Electrical Characteristics is not implied. Exposure to absolute maximum rated conditions for extended periods may affect device reliability. Due to the low dissipated power in this device, it is assumed that TJ = TA.

1.8 V VDD 6.5 V, RLRESET 100 k, CLRESET = 50 pF, over operating temperature range (TJ to +125C), unless otherwise noted. Typical values are = 25C.

PARAMETER VDD IDD Input supply range VDD 3.3 V, RESET not asserted MR, RESET, CT open VDD 6.5 V, RESET not asserted MR, RESET, CT open 1.3 V VDD 1.8 V, IOL 1.8 V VDD 6.5V, IOL 1.0 mA VOL (max) 0.2 V, IRESET 15A TPS3808G01 VIT V < VIT 5.0 V VSENSE = VIT VSENSE 6.5 V VRESET 6.5 V, RESET not asserted CT pin Other pins VIN V to VDD VIN V 0.3 VDD 0.7 VDD SENSE CT = Open td RESET delay time CT = VDD 180 nF Propagation delay tpHL JA (1) High to low level RESET delay Thermal resistance, junction-to-ambient The lowest supply voltage (VDD) at which RESET becomes active. Trise(VDD) 15 s/V. MR to RESET VIH = 0.7 VDD, VIL = 0.3 VDD See timing diagram VIH = 1.05 VIT, VIL = 0.95 VIT VIH = 0.7 VDD, VIL = 0.3 VDD TPS3808G01 Fixed versions TEST CONDITIONS MIN 2.4 2.7 TYP MAX %VIT ns s C/W % UNIT A V

Low-level output voltage Power-up reset voltage (1)

MR Internal pull-up resistance Input current at SENSE pin RESET leakage current Input capacitance, any pin MR logic low input MR logic high input Maximum transient duration


Related products with the same datasheet
Some Part number from the same manufacture Texas Instruments, Inc.
TPS3808G12DBVR Low Quiescent Current, Programmable-delay Supervisory Circuit
TPS3809I50 3-pin Supply Voltage Supervisors
TPS3809I50DBVR ti TPS3809I50, 3-Pin Supply Voltage Supervisor
TPS3809I50QDBVRQ1 ti TPS3809I50-Q1, Automotive Catalog 3-Pin Supply Voltage Supervisor
TPS3809J25 3-pin Supply Voltage Supervisors
TPS3809J25DBVR ti TPS3809J25, 3-Pin Supply Voltage Supervisor
TPS3809J25QDBVRQ1 ti TPS3809J25-Q1, Automotive Catalog 3-Pin Supply Voltage Supervisor
TPS3809K33 3-pin Supply Voltage Supervisors
TPS3809K33DBVR ti TPS3809K33, 3-Pin Supply Voltage Supervisor
TPS3809K33QDBVRQ1 ti TPS3809K33-Q1, Automotive Catalog 3-Pin Supply Voltage Supervisor
TPS3809L30 3-pin Supply Voltage Supervisors
TPS3809L303DBVR 3-PIN Supply Voltage Supervisor

NE5534IP : ti NE5534, Low-noise High-speed Audio Operational Amplifier

PT7751 : Non-Isolated DC-DC Converters

SN74CBT6845CDWR : 8-Bit Fet 5-V Bus Switch With Precharged Outputs And -2 V Undershoot Protection

SN74S151D : Multiplexers ti SN74S151, 8-Line to 1-Line Data Selectors/multiplexers

THS6092IDR : Line Drivers and Receivers ti THS6092, 275-mA, +12V Adsl Cpe Line Driver

TLE2161AMJG : Excalibur JFET-input High-output-drive Mpower Operational Amplifiers

DRV1100PG4 : Interface - Drivers, Receivers, Transceiver Integrated Circuit (ics) Driver Tube 4.5 V ~ 5.5 V; IC HI-PWR DIFF DRIVER AMP 8-DIP Specifications: Number of Drivers/Receivers: 2/0 ; Type: Driver ; Voltage - Supply: 4.5 V ~ 5.5 V ; Package / Case: 8-DIP (0.300", 7.62mm) ; Packaging: Tube ; Protocol: xDSL ; Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant

TPS7A4525DCQR : Pmic - Voltage Regulator - Linear (ldo) Integrated Circuit (ics); IC REG LDO 2.5V 1.5A LN SOT223-6 Specifications: Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant

ADS1675REF : Eval Board - Analog To Digital Converter (adcs) Programmers, Development System; REFERENCE DESIGN BRD FOR ADS1675 Specifications: Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant

Same catergory

SQD300A40 : Darlington Transistor Module. is a Darlington power transistor module which a high speed, high power Darlington transistor. The transistor has a reverse paralled fast recovery diode. The mounting base of the module is electrically isolated from semiconductor elements for simple heatsink construction, IC 300A, VCEX 400/600V Low saturation voltage for higher efficiency. High DC current.

TA78DS08BP : Low Dropout Voltage Regulator.

Z89390 : 16-bit Digital Signal Processor. The is a CMOS Digital Signal Processor (DSP). Single-cycle instruction execution and a Harvard bus structure promotes efficient algorithm execution. The processor contains 512 word data RAM and 64K word of external program address space is accessible. Six register pointers provide circular buffering capabilities and dual operand fetching. Three vectored.

BR1004W : Silicon Bridge Rectifiers. Rating to 1000V PRV Surge overload rating to 125 Amperes peak Ideal for printed circuit board Reliable low cost construction utilizing molded plastic technique results in inexpensive product Lead solderable per MIL-STD-202 method 208 Mounting: thru hole for # 6 screw Mounting Polarity shown on side of case; Positive lead by beveled corner. Ratings at 25 ambient.

240UR060D : Standard Recovery Diodes. Diffused diode Wide current range High voltage ratings to 1200V High surge current capabilities Stud cathode and stud anode version Hermetic metal case Typical Applications Welders Power supplies Machine tool controls High power drives Medium traction applications Battery charges Free-wheeling diodes VRRM , maximum repetitive peak reverse voltage V VRSM.

PZU36B1 : Single Zener Diodes in a Sod323f Package. General-purpose Zener diodes SOD323F (SC-90) very small and flat lead Surface Mounted Device (SMD) plastic package. Total power dissipation: 310 mW Tolerance series: B: approximately B2, B3: sequential, approximately 2 % Small plastic package suitable for surface mounted design Wide working voltage range: nominal 36 V Table 1. Symbol VF Ptot Quick.

TSW-128-08-T-D-RA : Tin Through Hole, Right Angle Rectangular - Headers, Male Pin Connectors, Interconnect Header, Unshrouded; CONN HEADER 56PS .100 DL R/A TIN. s: Color: Black ; Connector Type: Header, Unshrouded ; Contact Finish: Tin ; Contact Mating Length: 0.230" (5.84mm) ; : - ; Mounting Type: Through Hole, Right Angle ; Number of Positions Loaded: All ; Number of Rows:.

SCEP147L-4R5 : Fixed Inductors, Coils, Choke 4.5H 13.6A 0.591" L x 0.587" W x 0.319" H (15.00mm x 14.90mm x 8.10mm) -; INDUCTOR SMD 4.50UH 13.6A 100KHZ. s: Inductance: 4.5H ; Tolerance: 20% ; Package / Case: 0.591" L x 0.587" W x 0.319" H (15.00mm x 14.90mm x 8.10mm) ; Packaging: Tape & Reel (TR) ; Type: - ; Current: 13.6A ; Mounting Type: Surface Mount ; Q @ Freq:.

CLP-103-02-G-D : Gold Surface Mount Board To Board - Headers, Receptacles, Female Socket Connectors, Interconnect Receptacle; CONN RCPT 6POS DUAL .05" SMD. s: Color: Black ; Connector Type: Receptacle ; Contact Finish: Gold ; Contact Finish Thickness: 10in (0.25m) ; : - ; Height Above Board: 0.090" (2.28mm) ; Height Stacking (Mating): - ; Mounting Type: Surface Mount.

TNPW2512160KBEEG : 160K Ohm 0.5W, 1/2W Chip Resistor - Surface Mount; RES 160K OHM 1/2W 0.1% 2512. s: Resistance (Ohms): 160K ; Power (Watts): 0.5W, 1/2W ; Tolerance: 0.1% ; Packaging: Tape & Reel (TR) ; Composition: Thin Film ; Temperature Coefficient: 25ppm/C ; Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant.

FEBFAN23SV10M_LVA : Power Management IC Development Tools 5.5V 10A Out; Eval Board for FAN23SV10M. s: Manufacturer: Fairchild Semiconductor ; Product: Evaluation Boards ; Type: DC/DC Converters, Regulators & Controllers ; Tool Is For Evaluation Of: FAN23SV10M ; Input Voltage: 7 V to 15 V ; Output Voltage: 0.6 V to 5.5 V ; /Function: Highlights the FAN23XX family of highly.

SS210P : 2 A, 100 V, SILICON, RECTIFIER DIODE, DO-214AC. s: Rectifier Configuration / Technology: Schottky ; Package: PLASTIC, SMAJ, 2 PIN ; Number of Diodes: 1 ; VRRM: 100 volts ; IF: 2000 mA ; RoHS Compliant: RoHS.

TLV320AIC3268 : TLV320AIC3268 Ultra Low Power Stereo Audio Codec. The TLV320AIC3268 (AIC3268) provides users with an integrated method to implement an audio system with multiple digital and analog audio streams as sources, and multiple output devices such as high-powered audio amplifiers. The integrated miniDSP allows users to differentiate their products by enabling.

0-C     D-L     M-R     S-Z