Details, datasheet, quote on part number: UCC3751
PartUCC3751
CategoryCommunication => Telephony => Tone Ringer
DescriptionSingle Line Ring Generator Controller
CompanyTexas Instruments, Inc.
DatasheetDownload UCC3751 datasheet
Quote
Find where to buy
 
  

 

Features, Applications

Novel Topology for Low-Cost, Efficient The UCC3751 controller is designed for driving a power stage that generGeneration of Ring Voltage ates low frequency, high voltage sinusoidal signals for telephone ringing applications. The controller and the power stage are most suitable for sin Provides DC Offset and "Talk Battery" gle line applications where low cost, high efficiency and minimum parts Voltage for Off-Hook Conditions count are critical. In addition to providing the sinusoidal ringing signal, the Selectable 20, 25 and 50 Hz Ring controller and the power stage are designed to provide the required DC Frequency voltage across the output when the phone goes off-hook. The DC voltage is also added as the offset to the ringing signal. This feature eliminates the Secondary (AC) Current Limiting need to have a separate talk battery voltage power supply as well as relays Allows Removal of AC Voltage under and drivers to switch between the ringing voltage and the talk battery. Off-Hook Conditions Primary Current Limiting to turn Power The UCC3751 directly drives primary side switches used to implement a push-pull resonant converter topology and transformer coupled sampling Stage off under Fault Conditions switches located on the secondary of the converter. For normal ring signal Operates from a Single 12V Supply generation, the primary switching frequency and secondary sampling frequency are precisely offset from each other by the ringing frequency to produce a high voltage low frequency alias signal at the output. The off-hook condition is detected by sensing the AC current and when AC limit is exceeded, the sampling frequency is set to be equal to the primary switching frequency to produce a DC output. The drive signal frequencies are derived from a high frequency (3579545 Hz) crystal. The primary switching frequency is 89.488 kHz and the sampling frequency 50 Hz less depending on the status of frequency select pins FS0 and FS1.

The circuits described in this datasheet are covered under US Patent #5,663,878 and other patents pending.

D1 LIN T1 VIN LR CR2 SAMPLING CIRCUIT UCC3751 12 DRVS 2 RINGEN 6 OHD 4 VDD ENABLE CBYP2 AC SIGNAL CF VOUT CDC DC SIGNAL V1 RSENSE

Input Supply Voltage. 14V Analog Inputs (OHD, DCLIM, XTAL1, XTAL2) Maximum Forced Voltage. to 5V Logic Inputs Maximum Forced Voltage. to 7.5V Reference Output Current (VDD). Internally Limited Output Current (DRV1, DRV2, DRVS) Pulsed. 1.5A Operating Junction Temperature. to +125C Storage Temperature. to +150C

Note: Unless otherwise indicated, voltages are referenced to ground and currents are positive into, negative out of, the specific terminals. Pulsed is defined as a less than 10% duty cycle with a maximum duration 500 S.


ELECTRICAL CHARACTERISTICS: Unless otherwise stated, these specifications hold for to 70C for the UCC3751 and to +85C for the TA = TJ.

PARAMETER V12 Supply Current Section Supply Current ENABLE = 0V ENABLE = 5V Internal Reference with External Bypass Section Output Voltage (VDD) Load Regulation Line Regulation Short Circuit Current Output Drivers Section (DRV1, DRV2) Pull Up Resistance Pull Down Resistance Rise Time Fall Time Output Drivers Section (DRVS) Pull Up Resistance Pull Down Resistance Sample Pulse-Width Rise Time Fall Time Current Limit Section OHD Threshold OHD Input Current DCLIM Threshold DCLIM Input Current Frequency Section (Note 1) Primary Switching Frequency Sampling Switching Frequency All cases 3.579545 MHz Crystal = 0, Mode 1, (Note = 0, Mode = 1, Mode Hz VDCLIM = 0V VOHD mV nA ILOAD to 20mA ILOAD to 20mA Mode 1 and 2, (Note 1) CLOAD = 1nF CLOAD 1nF nS ILOAD to 20mA ILOAD to 20mA CLOAD = 1nF CLOAD nS 0mA IVDD < 13V, IVDD = 1mA VDD mV mA TEST CONDITIONS MIN TYP MAX UNITS


 

Some Part number from the same manufacture Texas Instruments, Inc.
UCC3751D ti UCC3751, Single Line Ring Generator Controller
UCC3752
UCC3752D ti UCC3752, Resonant Ring Generator Controller
UCC3776 Quad Fet Driver
UCC3776DP ti UCC3776, Quad Fet Driver
UCC3800 Low-power Bicmos Current-mode PWM
UCC3800D ti UCC3800, Low-power Bicmos Current-mode PWM
UCC3801 Low-power Bicmos Current-mode PWM
UCC3801D ti UCC3801, Low-power Bicmos Current-mode PWM
UCC3802 Low-power Bicmos Current-mode PWM
UCC3802D ti UCC3802, Low-power Bicmos Current-mode PWM
UCC3803 Low-power Bicmos Current-mode PWM
UCC3803D ti UCC3803, Low-power Bicmos Current-mode PWM
UCC3804 Low-power Bicmos Current-mode PWM
UCC3804D ti UCC3804, Low-power Bicmos Current-mode PWM
UCC3805 Low-power Bicmos Current-mode PWM
UCC38050 Transition Mode PFC Controller
UCC38050D ti UCC38050, Transition Mode PFC Controller
UCC38050DR Transition Mode PFC Controller
UCC38050DR ti UCC38050, Transition Mode PFC Controller
UCC38050P Transition Mode PFC Controller
Same catergory

AM79C970AKCW : Pcnet-pci ii Single-chip Full-duplex Ethernet Controller For Pci Local Bus Product.

APE5212 : Very Low Cost Voice And Melody Synthesizer With 4-bits Cpu. Sales E-mail: sales@aplusinc.com.tw Technology E-mail: service@aplusinc.com.tw Address: 3 F-10, No. 32, Sec. 1, Chenggung Rd., Taipei, Taiwan 115, R.O.C. TEL: 886-2-2782-9266 FAX: 886-2-2782-9255 WEBSITE : http: //www.aplusinc.com.tw The APExx12 series are very low cost voice and melody synthesizer with 4-bits CPU. They have various including 4-bits.

CD74HC4051 : High Speed CMOS Logic Analog Multiplexers/ Demultiplexers. Data sheet acquired from Harris Semiconductor SCHS122D High Speed CMOS Logic Analog Multiplexers/Demultiplexers PART NUMBER CD74HCT4053M96 CD74HCT4053PWR NOTE: 1. When ordering, use the entire part number. The suffixes 96 and R denote tape and reel. TEMP. RANGE (oC) to 125 PACKAGE 16 Ld CERDIP 16 Ld CERDIP 16 Ld CERDIP 16 Ld CERDIP 16 Ld PDIP 16 Ld SOIC.

DP83901A : DP83901A - Snic Serial Network Interface Controller, Package: Plcc, Pin Nb=68.

FT8U232AM : U-uart - Usb Ultrabaud Data Transfer ic With Rs232 /rs422 And Cpu I/f Options.

HFBR-5921L : 2.125/1.0625 GBD 850nm Vcsel Low Voltage (3.3V) Transceiver For Fibre Channel in 2x5 SFF PTH Package.

HFBR2416C : Low Cost, Miniature Fiber Optic Components With St, Sma, SC And FC Ports.

L84302 : Controllers. Quad 100/10 MBPS 4-Port Ethernet Controller With Rmon/snmp Management Counters Technical Manual 4/02.

M67749SHR : RF Power Module For 490-512MHz, 12.5V, 7W FM Portable Radio.

M68701H : Module->500 MHz. RF Power Module For 890-960MHz, 6W FM Digital Radio.

MAX3996EVKIT : MAX3996EVKIT Evaluation Kit For The MAX3996. The MAX3996 evaluation kit (EV kit) is an assembled demonstration board that provides both optical and electrical evaluation of the MAX3996 2.5Gbps laser driver. The output of the electrical evaluation section is interfaced to an SMA connector that can be connected a 50 terminated oscilloscope. The output of the optical evaluation section is configured.

MSM5218 : Adpcm Voice Analysis/synthesis ic. The is a complete voice analysis/synthesis IC featuring the Adaptive Differential Pulse Code Modulation (ADPCM) method of data compression. The MSM5218 contains an analysis stage where serial PCM data is compressed or 4-bit parallel ADPCM data. In addition, a synthesis stage synthesizes PCM data from ADPCM data. ADPCM data compatible with OKI's synthesis.

PCD3310 : PCD3310; PCD3310A; Pulse And DTMF Diallers With Redial. Product Supersedes data of 1996 May 06 File under Integrated Circuits, IC03 1996 Nov 21 CONTENTS GENERAL QUICK REFERENCE DATA ORDERING INFORMATION BLOCK DIAGRAM PINNING FUNCTIONAL Power supply (VDD and VSS) Clock oscillator (OSCI and OSCO) Chip enable (CE) Mode selection (PD/DTMF) Pulse mode DTMF mode Mixed mode Keyboard inputs/outputs Flash duration.

S558-5999-74 : LAN Magnetic. XFMR Module, 10/100Base-TX. Quad, four-port designs optimize board layout for single row and dual stack RJ-45 connectors Tested for use with multiple 10/100 Mbps and 100 Mbps PHY transceivers requiring 1CT TX and 1 RX transformers Operating temperature 70 C Meets all IEEE 802.3 standards including 350H with 8mA DC bias Low profile, surface mount packaging rated 225 C peak IR reflow.

SERGBQA : Sercos Interface Controller. USE IN LIFE SUPPORT DEVICES OR SYSTEMS MUST BE EXPRESSLY AUTHORIZED. SGS-THOMSON PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF SGS-THOMSON Microelectronics. As used herein : 1. Life support devices or systems are those which (a) are intended for surgical implant.

SMJ320C6201BGLE : Digital Signal Processors. Highest Performance Fixed-Point Digital Signal Processor (DSP) 6.67-ns Instruction Cycle Time 150-MHz Clock Rate Eight 32-Bit Instructions/Cycle 1 200 MIPS Highest Performance Fixed-Point Digital Signal Processor (DSP) 6.67-ns Instruction Cycle Time 150-MHz Clock Rate Eight 32-Bit Instructions/Cycle 1 200 MIPS VelociTITM Advanced Very Long.

TMP82C55AM-2 : CMOS Programmable Peripheral Interface.

TMS320WP010 : Digital Signal Processor For Aec/lec/ans. Cancels the Acoustic Echo Common in Hands-Free Use of Cellular Phones in Automobiles Eliminates Echo Created by Speaker Output Feeding Back Into the Microphone Suppresses Wind, Engine, and Tire Noise Line Echo Canceler Standard Independent IS-54B, IS-136, GSM, AMPS, IS-95 Continuous, Automatic Adaptation to Changing Acoustic Environment Initial.

W55FC200 : . Using Internet technologies to connect to web sites that offer more & more contents and play options is one of the most important function of Winbond Internet toy controller W55FC200 which is capable of downloading toy's sound files or motion data from toy company web site as well as allows toy's contents can be uploaded to PC. Similarly, the PC enhanced.

st2051 : The ST2051 power distribution switch is intended for applications where heavy capacitive loads and short circuits are likely to be encountered. These devices incorporate 90mΩ N-channel MOSFET high-side power switches for power-distribution. The switch is controlled by a logic enable input. Gate drive is provided by an internal charge pump designed.

 
0-C     D-L     M-R     S-Z