|
Details, datasheet, quote on part number:PQ-44
| |
| Part: | PQ-44 |
| Category: | RF & Microwaves => Phase Shifters |
| Description: | Description = Phase Shifter, Continuously Variable ;; Freq. Range = 0.1-18 GHZ |
| Company: | MCE KDI Integrated Products |
| Datasheet: | Download PQ-44 datasheet File size : 158 kB |
| Request For quote: | Find where to buy PQ-44
|
| |
Datasheet text preview:
ANALOG DIODE
PHASE SHIFTERS
CONTINUOUSLY VARIABLE -- 0.118 GHz GENERAL INFORMATION
An analog phase shifter continuously changes the phase of a microwave signal by varying a D.C. voltage. Since the D.C. voltage applied to the diode is a reverse bias, the current drain is negligible (typically less than 10 microamps). A balanced stripline configuration keeps the VSWR and amplitude ripple to a minimum for all values of phase.
SERIES PQ
GENERAL SPECIFICATIONS
Frequency Coverage: RF impedance: D.C. Voltage: 0.1 to 18.0 GHz 50 OHMS. 0 volts to +28 volts (standard), or 0 volts to 28 volts (optional) will vary the phase of any of the models over the minimum phase shift listed 10 mW peak or CW, operating. Destruct level is 1 W, CW, 100 W peak. The units can be used over a 55°C to +85°C temperature range. However, the phase will change either ±5° or ±5%, whichever is greater. If temperature compensation is required, this can be done on request. With compensation, the variation can be held to ±1° or ±1%, whichever is greater, from 55°C to +85°C. The size remains the same. If compensation is desired, add a suffix T to the model number (e.g., PQ-17T). Series PQ phase shifters can be driven from any phase value to any other value in 10 nanoseconds. With linearizers, the response time is 50 nanoseconds. With temperature compensation the response time is 100 nanoseconds. SMA
PHASE SHIFT (DEGREES) 150 120 90 60 30 PHASE SHIFT 0 5 10 15 20 25 30 1.0 INSERTION LOSS (dB) .8 .6 .4 .2 0 VOLTAGE (V)
RF Power: Temperature Information:
INSERTION LOSS
Switching Speed:
Fig. 1 Typical Phase & Insertion Loss vs. Voltage Curves for PQ-31
Connectors:
Notes:
1. LINEARIZATION: For phase shifters with linearizers add a suffix L to the model number (e.g., PQ-23L). Linearity is ±2.0° for phase shifters for 150° or less, and ±4° for phase shifters between 150° and 360°. With linearization, DC voltages of ±15V at ±30mA are required. The control voltage is 010 volts. A control voltage of 05 volts can be supplied at no additional cost, by adding a suffix 5 to the model number (e.g. PQ-23L5). Linearity is measured at fc. 2. PHASE FLATNESS: The phase shift varies with frequency at any voltage setting. This variation, referenced to 0° at 0 volts for each frequency, is approximately ±15% for octave models, ± 10% for models with 25% bandwidth, and ±7.5% for models with a 10% bandwidth. 3. A connector, (SMA Female) is available in place of the bias pin at no extra charge. This will be placed at the center of the surface marked F on the drawing. This is the 0.38 × A surface. If a SMA Female is desired, add suffix C to the model number (e.g., PQ23C). 4. Monotonicity guaranteed for all models.
S (DEG) PHASE SHIFT
yyyyyyyyyyyyyyyyyyy ,,,,,,,,,,,,,,,,,,, yyyyyyyyyyyyyyyyyyy ,,,,,,,,,,,,,,,,,,, yyyyyyyyyyyyyyyyyyy ,,,,,,,,,,,,,,,,,,, 160 ,,,,,,,,,,,,,,,,,,, yyyyyyyyyyyyyyyyyyy yyyyyyyyyyyyyyyyyyy ,,,,,,,,,,,,,,,,,,, yyyyyyyyyyyyyyyyyyy ,,,,,,,,,,,,,,,,,,, yyyyyyyyyyyyyyyyyyy ,,,,,,,,,,,,,,,,,,, yyyyyyyyyyyyyyyyyyy ,,,,,,,,,,,,,,,,,,, yyyyyyyyyyyyyyyyyyy 100 ,,,,,,,,,,,,,,,,,,, yyyyyyyyyyyyyyyyyyy ,,,,,,,,,,,,,,,,,,, yyyyyyyyyyyyyyyyyyy ,,,,,,,,,,,,,,,,,,, yyyyyyyyyyyyyyyyyyy ,,,,,,,,,,,,,,,,,,, yyyyyyyyyyyyyyyyyyy ,,,,,,,,,,,,,,,,,,, 40 ,,,,,,,,,,,,,,,,,,, yyyyyyyyyyyyyyyyyyy yyyyyyyyyyyyyyyyyyy ,,,,,,,,,,,,,,,,,,, yyyyyyyyyyyyyyyyyyy ,,,,,,,,,,,,,,,,,,, yyyyyyyyyyyyyyyyyyy ,,,,,,,,,,,,,,,,,,,
0.4 1.0 1.6
BIAS VOLTAGE VB (V)
Fig. 2 Phase shift characteristic of PQ-45.
KEY: Inches[Millimeters] .XX ±.03 .XXX ±.010 [.X ±0.8 .XX ±0.25]
60 South Jefferson Road, Whippany, NJ 07981 Tel: 973-887-8100 · Fax: 973-884-0445 email: sales@mcekdi-integrated.com See us on the web @ www.mcekdi-integrated.com
11-5-02
ANALOG DIODE
PHASE SHIFTERS
CONTINUOUSLY VARIABLE -- 0.118 GHz
F SURFACE 0.25[6,3] GROUND E BIAS PIN 0.25[6,3] C.V. +15V E
SERIES PQ
15V GND
SMA FEMALE TYP.
D
B
SMA FEMALE TYP.
D
B
RF C A
RF 0.20 [5,1]
RF
0.40 [10,2]
0.10[2,5] TYP.
F 0.093[2,36] DIA. THRU 3 MOUNTING HOLES 0.38[9,7] TYP.
0.10[2,5] TYP. 1.00 [25,4]
C A 0.125[3,18] DIA. THRU 3 MOUNTING HOLES
F 0.38[9,7] TYP.
OUTLINE WITHOUT LINEARIZER
OUTLINE WITH LINEARIZER
ELECTRICAL PERFORMANCE
Phase Shift Insertion Amplitude Note 2 Loss Ripple Outline Frequency Minimum Maximum Maximum VSWR No With Model No.* Range GHz Degrees dB ± dB Maximum Linearizer Linearizer PQ-12 0.10.2 50 0.6 0.15 1.35 1 1 PQ-14 0.20.4 50 0.6 0.15 1.35 1 1 PQ-17 0.250.5 360 4.5 1.25 1.70 10 10 PQ-27 0.51.0 180 3.0 0.4 1.50 3 3 PQ-28 0.51.0 360 4.5 1.25 1.75 4 4 PQ-31 0.951.25 120 1.2 0.15 1.40 1 1 PQ-33 1.02.0 60 0.8 0.15 1.50 2 6 PQ-34 1.02.0 360 4.5 1.5 1.80 8 4 PQ-39 1.72.4 15 0.7 0.05 1.40 2 6 PQ-44 2.04.0 180 3.0 0.50 1.60 3 3 PQ-45 PQ-49 PQ-59 PQ-60 PQ-65 PQ-66 PQ-72 PQ-73 PQ-74 PQ-94 2.04.0 2.22.3 4.08.0 4.08.0 6.018.0 7.012.4 8.012.4 8.010.0 8.018.0 16.017.0 360 180 40 360 180 360 60 180 360 50 5.0 2.0 1.2 8.0 12.0 12.0 2.0 5.0 17.0 2.0 1.5 0.30 0.25 1.5 2.0 2.0 0.50 1.0 3.5 0.20 1.90 1.50 1.60 1.90 2.5 2.20 1.75 1.75 2.50 1.65 5 3 2 9 7 9 2 7 9 2 5 3 6 9 7 9 6 7 9 6
MECHANICAL OUTLINES
Outline 1 2 3 4 5 6 7 8 9 10 A in [mm] 2.75 [69,91] 1.25 [31,75] 5.00 [127,0] 7.75 [196,8] 6.50 [165,1] 2.00 [50,8] 3.00 [76,2] 6.50 [165,1] 5.00 [127,0] 7.75 [196,8] B in [mm] 2.25 [57,15] 2.00 [50,8] 2.00 [50,8] 2.50 [63,5] 2.00 [50,8] 2.00 [50,8] 2.00 [50,8] 2.50 [63,5] 2.00 [50,8] 2.50 [63,5] C in [mm] 1.38 [35,05] 0.63 [16,0] N/A 4 holes N/A 4 holes N/A 4 holes 1.00 [25,4] 1.50 [38,1] N/A 4 holes N/A 4 holes N/A 4 holes D in [mm] 2.050 [52,07] 1.800 [45,7] 1.800 [45,7] 2.300 [58,42] 1.800 [45,7] 1.800 [45,7] 1.800 [45,7] 2.300 [58,42] 1.800 [45,7] 2.300 [58,42] E in [mm] 2.250 [57,15] 0.750 [19,1] 4.500 [114,3] 7.250 [184,15] 6.000 [152,4] 1.500 [38,1] 2.500 [63,5] 6.000 [152,4] 4.500 [114,3] 7.250 [184,15] F in [mm] 0.53 [13,46] 0.25 [6,4] 0.25 [6,4] 0.25 [6,4] 0.25 [6,4] 0.25 [6,4] 0.25 [6,4] 0.25 [6,4] 0.50 [12,7] 0.75 [19,1]
*OPTIONS: (Add to Model No.) T Temp. Comp. L Linearization C Bias Connector -- SMA 5 0 to 5 Volts Control Voltage for Linearized Models.
KEY: Inches[Millimeters] .XX ±.03 .XXX ±.010 [.X ±0.8 .XX ±0.25]
An MCE Company
CORPORATION
TRIANGLE
60 South Jefferson Road, Whippany, NJ 07981 Tel: 973-887-8100 · Fax: 973-884-0445 E-Mail: kdisales@aol.com See us on the web @ www.kditriangle.com
10/98
|
|
