Details, datasheet, quote on part number: HYM72V1630GS-50
PartHYM72V1630GS-50
CategoryAnalog & Mixed-Signal Processing => Amplifiers => High Dynamic Range Amplifiers
Description16m X 72-bit Dynamic RAM Module
CompanySiemens (acquired by Infineon Technologies Corporation)
DatasheetDownload HYM72V1630GS-50 datasheet
  

 

Features, Applications

168 Pin JEDEC Standard, Buffered 8 Byte Dual In-Line Memory Module for PC main memory applications 1 bank x 72 organisation Optimized for ECC applications Fast Page Mode Operation Performance:: -50 tRAC tCAC tAA tRC tPC RAS access time CAS access time Access time from address Read/Write cycle time Fast page mode cycle time ns

Single 0.3V) supply CAS-before-RAS refresh, RAS-only-refresh Decoupling capacitors mounted on substrate All inputs, outputs and clock fully LVTTL & LVCMOS compatible 4 Byte interleave enabled, Dual Address inputs (A0/B0) Buffered inputs excepts RAS and DQ Parallel Presence Detects Utilizes eighteen 4 -DRAMs and four BiCMOS buffers/line drivers Two versions : HYM 72V1620GS with TSOPII-components (4 mm thickness) HYM 72V1630GS with SOJ-components (9 mm thickness) 8192 refresh cycles 128 ms with / 11 addressing Gold contact pad Double sided module with mm (1500 mil) height

The HYM a 128 MByte DRAM module organized 777 216 words a 168-pin, dual read-out, single-in-line package comprising eighteen HYB 4 DRAMs in 400 mil wide TSOPII or SOJ- packages mounted together with ceramic decoupling capacitors a PC board. All inputs except RAS and DQ are buffered by using BiCMOS buffers/line drivers. Each HYB 3164400AT/AJ is described in the data sheet and is fully electrically tested and processed according to Siemens standard quality procedure prior to module assembly. After assembly onto the board, a further set of electrical tests is performed. The density and speed of the module can be detected by the use of presence detect pins.

Ordering Information Type HYM 72V1620GS-50 HYM 72V1620GS-60 HYM 72V1630GS-50 HYM 72V1630GS-60 Pin Names OE0, OE2 Vcc Vss - PD8 PDE , ID1 N.C. Presence-Detect and ID-pin Truth Table: Module ID0 ID1 Vss PD8 0 Address Input Data Input/Output Row Address Strobe Column Address Strobe Read / Write Input Output Enable Power (+3.3 Volt) Ground Presence Detect Pins Presence Detect Enable ID indentification bit No Connection Ordering Code Package L-DIM-168-9 Descriptions 3.3V 50ns DRAM module 3.3V 60ns DRAM module 3.3V 50ns DRAM module 3.3V 60ns DRAM module

Note: 1 = High Level ( Driver Output) 0 = Low Level (Driver Output) for PDE active ( ground). For PDE at a high level all PD terminal are in tri-state.

PIN Symbol VSS DQ2 DQ3 VCC DQ7 DQ8 VSS DQ12 DQ13 VCC DQ16 DQ17 VSS NC VCC RAS0 OE0 VSS A10 A12 VCC NC PIN Symbol VSS NC WE2 VCC DQ18 DQ19 VSS DQ22 DQ23 VCC DQ26 DQ27 VSS DQ30 DQ31 VCC DQ34 DQ35 VSS PD7 ID0 (VSS) VCC PIN Symbol VSS DQ38 DQ39 VCC DQ43 DQ44 VSS DQ48 DQ49 VCC DQ52 DQ53 VSS NC VCC NC VSS A11 NC VCC NC B0 PIN Symbol VSS NC PDE VCC DQ54 DQ55 VSS DQ58 DQ59 VCC DQ62 DQ63 VSS DQ66 DQ67 VCC DQ70 DQ71 VSS PD8 ID1 (VSS) VCC


 

Related products with the same datasheet
HYM72V1630GS-60
Some Part number from the same manufacture Siemens (acquired by Infineon Technologies Corporation)
HYM72V1630GS-60 16m X 72-bit Dynamic RAM Module
HYM72V1635GS-50 16m X 72-bit Edo-dram Module
HYM72V2005GS-50 2m X 72-bit Edo-dram Module
HYM72V4000GS-50 4m X 72-bit Dynamic RAM Module
HYM72V4010GS-50
HYM72V4015GS-50 4m X 72-bit Edo-dram Module
HYM72V4045GU-50 3.3v 4m X 64-bit Edo-dram Module 3.3v 4m X 72-bit Edo-dram Module
HYM72V8000GS-50 8m X 72-bit Dynamic RAM Module
HYM72V8005GU-50 3.3v 8m X 64-bit Edo-dram Module 3.3v 8m X 72-bit Edo-dram Module
HYM72V8010GS-50 8m X 72-bit Dynamic RAM Module
HYM72V8020GS-50
HYM72V8025GS-50 8m X 72-bit Edo- DRAM Module
HYM72V8030GS-50 8m X 72-bit Dynamic RAM Module
HYM72V8035GS-50 8m X 72-bit Edo- DRAM Module
HYM72V8045GU-50 3.3v 8m X 64-bit Edo-dram Module 3.3v 8m X 72-bit Edo-dram Module
HYS64-72V2200GU-8 3.3v 2m X 64/72-bit 1 Bank Sdram Module 3.3v 4m X 64/72-bit 2 Bank Sdram Module
HYS64-74V8200GU 3.3 V 8m X 64/72-bit 1 Bank Sdram Module 3.3 V 16m X 64/72-bit 2 Bank Sdram Module
HYS6472V16200GU 3.3 V 16m X 64/72-bit Sdram Modules 3.3 V 32m X 64/72-bit Sdram Modules 3.3 V 64m X 64/72-bit Sdram Modules
HYS6472V4200GU 3.3v 4m X 64/72-bit 1 Bank Sdram Module 3.3v 8m X 64/72-bit 2 Bank Sdram Module
HYS64V1000GS-10 3.3v 1m X 64-bit Sdram Module 3.3v 1m X 72-bit Sdram Module
HYS64V16200GU-8 3.3 V 16m X 64/72-bit Sdram Modules 3.3 V 32m X 64/72-bit Sdram Modules 3.3 V 64m X 64/72-bit Sdram Modules
Same catergory

4214AP : ti 4214, Multiplier-divider.

AD8531 : Low Cost, 250 ma Output Single-supply Amplifiers. Single-Supply Operation: 2.7 Volts to 6 Volts High Output Current: 250 mA Low Supply Current: 750 A/Amplifier Wide Bandwidth: 3 MHz Slew Rate: 5 V/s No Phase Reversal Low Input Currents Unity Gain Stable APPLICATIONS Multimedia Audio LCD Driver ASIC Input or Output Amplifier Headphone Driver The AD8531, AD8532 and AD8534 are single, dual and quad rail-to-rail.

AD8598 : Dual 7 NS Single Supply Comparator (10/98). 7 ns Propagation Delay Single Supply Operation: +10 V Low Power Symmetrical Layout Latch Function TSSOP Packages APPLICATIONS Clock Recovery and Clock Distribution High Speed Data Line Receivers Phase Detectors Digital Communications I and Q Detection High Speed Sampling Upgrade for MAX912 Satellite Receivers PCMCIA Cards Wireless Data Links Battery.

AD9884 : Triple 8-Bit, 140 MSPS ADC, RGB Graphics Digitizer For Sxga LCD Monitors.

HA17301P : Quad Operational Amplifier. The is an internal-compensation quad operational amplifier that operates on a single-voltage power supply. Typical applications for the HA17301P include waveform generators, voltage regulators, logic circuits, and voltage-controlled oscillators. Wide operating temperature range Single-voltage power supply operation Internal phase compensation Low input.

LC75396NE : Electronic Volume Control. The is an electronic volume control system providing control over volume, balance, 5-band equalizer, and input switching based on serial inputs. Volume control: The chip provides 81 levels of volume attenuation: in 1dB step between 0 dB and 79 dB and Independent control over left front/rear and right front/rear channels provides balance control. Equalizer:.

LH0101 : Power Operational Amplifier (discontinued). The is a wideband power operational amplifier featuring FET inputs internal compensation virtually no crossover distortion and rapid settling time These make the LH0101 an ideal choice for or AC servo amplifiers deflection yoke drives programmable power supplies and disk head positioner amplifiers The LH0101 is packaged an 8 pin TO-3 hermetic package.

LM3303J : Quad Operational Amplifiers. The LM3303 and LM3403 are monolithic quad operational amplifiers consisting of four independent high gain internally frequency compensated operational amplifiers designed to operate from a single power supply or dual power supplies over a wide range of voltages The common mode input range includes the negative supply thereby eliminating the necessity.

LT1225 : LT1225, Very High Speed Operational Amplifier (Av => 5). Gain of 5 Stable 150MHz Gain Bandwidth 400V/s Slew Rate 20V/mV DC Gain, 500 1mV Maximum Input Offset Voltage 12V Minimum Output Swing into 500 Wide Supply Range: 15V 7mA Supply Current 90ns Settling Time 0.1%, 10V Step Drives All Capacitive Loads The is a very high speed operational amplifier with excellent DC performance. The LT1225 reduced input.

LTC1164 : LTC1164-5, 8th Order, 20kHz, Butterworth or Bessel, Low Pass Filter. LTC1164 Low Power, Low Noise, Quad Universal Filter Building Block Low Power 4 Filters a 0.3" Wide Package 1/2 the Noise of the 60, 61 Devices Wide Output Swing Clock-to-Center Frequency Ratios of 50:1 and 100:1 Operates from to 8V Power Supplies Customized Version with Internal Resistors Available Ratio of 50:1 and 100:1 Simultaneously Available Antialiasing.

OPA2544T : Power Operational Amplifiers. ti OPA2544, High-Voltage, High-current Dual Operational Amplifier.

SAB9076H : SAB9076H; Picture-in-picture (PIP) Controller. Preliminary File under Integrated Circuits, IC02 1996 Aug 13 Display Twin PIP in interlaced mode at 8-bit resolution Sub-title mode built in Large display fine positioning area, both channels independent Only 2 Mbit required as external VDRAM 1 Mbit 2 Mbit) Four 8-bit Analogue Digital Converters (ADCs; > 7-bit performance) with clamp circuit.

SK10EL16TA-TD : Differential Receiver. The SK10/100EL16TA-TD are differential receivers with optional input/output terminations. The EL16TA-TD family is pin-to-pin compatible with SK10/100EL16W and Motorola's MC10/100EL16 and MC10/100LVEL16, with added of input/output terminations. The different options of input/output terminations of the EL16TA-TD make them ideal for use in high frequency.

THS4221D : ti THS4221, Low-distortion High-speed Rail-to-rail Output Operational Amplifier.

THS6053CD : Line Drivers and Receivers. ti THS6053, 175-mA, +/-12V Adsl Cpe Line Driver With Shutdown.

LTC6103 : Dual High Voltage, High Side Current Sense Amplifier The LTC6103 is a versatile, high voltage, high side, dual current sense amplifier. The two internal amplifiers are independent except that they share the same V terminal. Design flexibility is provided by the excellent device characteristics: 450V maximum offset, and only 275A of current consumption.

SGM5018 : 4.5?, High Speed, Low Voltage, Quad, SPDT Analog Switch The SGM5018 is a high-speed, low-voltage, quad single-pole/double-throw (SPDT) CMOS analog switch multiplexer that is designed to operate from a single +1.8V to +5.5V power supply. SGM5018 guaranteed on-resistance (4.5? TYP), on-resistance matching (3.6? MAX) between switches and guaranteed on-resistance.

 
0-C     D-L     M-R     S-Z