Details, datasheet, quote on part number: KBPC1004G
PartKBPC1004G
CategoryPower Management => AC-DC Controllers/Converters => Bridge Rectifiers
DescriptionSingle Phase 10.0 Amps. Glass Passivated Bridge Rectifiers
CompanyJinan Gude Electronic Device
DatasheetDownload KBPC1004G datasheet
Quote
Find where to buy
 
  
Some Part number from the same manufacture Jinan Gude Electronic Device
KBPC1006G Single Phase 10.0 Amps. Glass Passivated Bridge Rectifiers
KBPC1008G
KBPC1010G
MDB051 Single Phase 0.5 Amp Glas Passivated Bridge Rectifiers
MDB054
MDB056
MDBL054
MSB051
MSB054
MSB056
MSBL054 Single Phase 0.5 Amp Glass Passivated Bridge Rectifiers
RB151G Miniature Single Phase 1.5 Amps. Glass Passivated Bridge Rectifiers
RB156G
RB157G
RC2005 Single Phase 2.0 Amps. Silicon Bridge Rectifiers
RC208
RC210
SF11L 1.0 Amp. Super Fast Rectifiers
SF225 2.0 Amps. Surface Mount Schottky Barrier Rectifiers
SFA11 1.0 Amps. Super Fast Rectifiers
SFR1A1 1.0 Amp. Soft Fast Recovery Rectifiers
Same catergory

BP5302A : . The BP5302A and BP5302XA are / DC converters for supplying power to liquid crystal display (LCD) panels. The modules supply a negative voltage from a positive power supply. They are available in a single in-line package as an upright (BP5302A) or L-shaped lead (BP5302XA) type. Applications LCD panels in personal computers and word processors 1) Wide.

BQ2150LMODULE : Gas Gauges. ti BQ2150, Gas Gauge Module With Leds And Switch (L-version), BQ2050 Based.

HV514 : High Voltage Driver. Source/sink Outputs Push-pull. HV514 8-Channel Serial to Parallel Converter with High Voltage Push-Pull Outputs HVCMOS, technology Operating output voltage of 250V Low power level shifting from to 250V Shift clock speed VDD=5V 8 latch data outputs Output blanking CMOS compatible inputs Programmable POL latch The is a low voltage serial to high voltage parallel converter with 8 high.

LTC1054 : . LT1054/LT1054L Switched-Capacitor Voltage Converter with Regulator Available in Space Saving SO-8 Package Output Current: 125mA (LT1054L) Low Loss: at 100mA Operating 7V (LT1054L) Reference and Error Amplifier for Regulation External Shutdown External Oscillator Synchronization Can Be Paralleled Pin Compatible with the LTC1044/LTC7660 The is a monolithic,.

LX8386B-00 : 1.5 a Low Dropout Positive Regulators. The LX8386/86A/86B series ICs are positive regulators designed to provide 1.5A output current. These regulators yield higher efficiency than currently available devices with all internal circuitry designed to operate down a 1V input-to-output differential. In this product, the dropout voltage is fully specified as a function of load current. Dropout.

MAX1958 : MAX1958, MAX1959 W-cdma/n-cdma Cellular Phone HBT pa Management Ics. o Step-Down Converter Dynamically Adjustable Output Voltage from 3.4V (MAX1958) Dynamically Adjustable Output Voltage from (MAX1959) 800mA Guaranteed Output Current 130mV IC Dropout at 600mA Load Low Quiescent Current 190A (typ) in Skip Mode (MAX1958) 3mA (typ) in PWM Mode 0.1A (typ) in Shutdown Mode 1MHz Fixed-Frequency PWM operation to 100% Duty-Cycle.

MSK3015 : Three Phase Bridge MOSFET Power Module. THREE PHASE BRIDGE MOSFET POWER MODULE 4707 Dey Road Liverpool, N.Y. 13088 All N-Channel Mosfets Isolated Package for Direct Heat Sinking, Excellent Thermal Conductivity Avalanche Rated Devices Interfaces with Most Brushless Motor Drive IC's 100 Volt, 23 Amp Full Three Phase Bridge at 25C The MSK is an all N-Channel three phase power MOSFET Bridge.

REF1112AIDBZR : ti REF1112, 1uA, SOT23-3 10ppm/C Shunt Voltage Reference. z MICRO-PACKAGE: SOT23-3 z WIDE CURRENT RANGE: 5mA z HIGH INITIAL ACCURACY: 0.2% z EXCELLENT SPECIFIED DRIFT PERFORMANCE: 30ppm/C (max) from +70C 50ppm/C (max) from to +85C APPLICATIONS z BATTERY-POWERED INSTRUMENTS z PORTABLE DEVICES z MEDICAL EQUIPMENT z CURRENT SOURCES z CALIBRATORS z MICROPOWER CURRENT AND VOLTAGE REFERENCE The is a two-terminal.

S494 : PWM. Power Supply Controller , PWM. The is a monolithic integrated circuit which includes all the necessary building blocks for the design of pulse width modulate(PWM) switching power supplies, including push-pull, bridge and series configuration. The device can operate at switching frequencies between 1KHz and 300KHz and output voltage to 40V. The S494 is specified over an operating.

TPIC5223LD : Control and Monitoring->Power+ Arrays. ti TPIC5223L, 2-Channel Independent Driver.

US3022 : 4 Bit Programmable Synchronous Buck Plus Four LDO Controller. 4 BIT PROGRAMMABLE SYNCHRONOUS BUCK PLUS FOUR LDO CONTROLLER Provides Single Chip Solution for Vcore, GTL+ ,AGP Bus, , 2.5V Automatic Voltage Selection for AGP slot's Vddq supply 4 Linear regulator controller on board to achieve lowest system cost solution Standby Vref provides reference for the ACPI regulators Designed to meet Intel Latest VRM for next.

AAT3131 : The AAT3131 is a low noise, constant frequency charge pump DC/DC converter that uses a dual mode load switch (1X) and fractional (1.5X) conversion to maximize efficiency for white LED applications. The device can be used to produce current levels up to 20mA in three of its outputs and 30mA in one of its outputs to drive LEDs from a 2.7V to 5.5V input.

AS1325 : Step-up DC-DC Converter The AS1325 is a high-efficiency step-up DC-DC converter designed to generate a fixed output voltage of +3.3V or +5V. The AS1325 achieves an efficiency of up to 96% and the minimum input voltage is 1.5V. The AS1325-BSTT-33 delivers up to 300mA output current at the fixed output voltage of +3.3V (@ 2V VBATT). With the fixed output.

AP3154A : Backlight Driver ICs The AP3154A is a high efficiency charge-pump white LED driver with 1x, 1.5x, 2x operating modes. The AP3154A operates on power supplies from 2.7v to 5.5v. It drives up to four channels of white LEDs while the intensity of each channel is configured by varying the respective current levels. Each channel can supply up to 30mA current.

A8296 : Single LNB Supply And Control Voltage Regulator Intended for analog and digital satellite receivers, this single low noise block converter regulator (LNBR) is a monolithic linear and switching voltage regulator, specifically designed to provide the power and the interface signals to an LNB down converter via coaxial cable. The A8296 requires few external.

LT3507A : Triple Monolithic Step-Down Regulator With LDO The LT3507A is a triple, current mode, DC/DC converter with internal power switches and a low dropout regulator. The switching converters are step-down converters capable of generating one 2.7A output and two 1.8A outputs. All three converters are synchronized to a single oscillator. The 2.7A output runs.

 
0-C     D-L     M-R     S-Z